Without the simplification of all the resistors and capacitors having the same values, the calculations become more complex:
Oscillation criterion:
Rc phase shift uses negative feedback.. Weinbridge uses both +ve and -ve feedback
wein bridge in functional genertors by P.SELVARASU
The oscillator provides the basic clock of a microcontroller to be able to execute the instructions in a stable, periodic way. It is often used for other peripherals too, like timer, UART, etc. as frequency base, usually divided by a clock divider for integer factors, or by PLL for rational factors. If the timing accuracy of these functions is not important, a simple RC oscillator can be used. Many microcontrollers have it internally. Accuracy is in 1...10% range. For better accuracy and temperature stability, a resonator can be used. For applications where timing is critical, a crystal can be used. Most micros have built-in oscillator, so only a crystal and two caps are needed. For those which have no built-in oscillator, external crystal oscillator module may be used. There are OCXO and TCXO modules available for very high stability needs.
will there be at least a way or trick to run two different remote control car together with the same fixed frequencies
That is its function. An RC low pass circuit is an integrator.
no
Phase-shift oscillator Armstrong oscillator Cross-coupled LC oscillator RC oscillator
Advantages: it improves frequency stability. phase modulation n demodulation is easy as compared to frequency modulation.
phaseshift of wienbridge is 0
In order for an oscillator to be stable, its total phase shift must be 180 degrees. The most common design of an RC phase shift oscillator is three identical RC stages in series, which means that each stage contributes 60 degrees. For more information, please see the Related Link below.
Phase-shift oscillator Armstrong oscillator Cross-coupled LC oscillator RC oscillator
To obtain a phase-shift of 180 degree.
Rc phase shift uses negative feedback.. Weinbridge uses both +ve and -ve feedback
RC phase shift oscillator is used to generate frequency in audio range and it is a fixed audio frequency oscillator where as wien bridge oscillator is a variable audio frequency oscillator for high frequency oscillations it is better to design wide band amplifier with LC network
The frequency stability of oscillators depend on the rate of change of phase with frequency. RC sections help improve the frequency stability. The net phase shift introduced by the RC feedback network is 180 degrees ,which contains n sections.Thus each RC section introduces 180/n degree phase shift. When 2 RC sections are cascaded due to low phase change rate the frequency stability is low. For 3 sections cascaded the phase change rate is high and hence there is improved frequency stability. However for 4 RC sections there is an excellent phase change rate resulting in the most stable oscillator configuration. But 4 RC sections increases cost and makes circuit bulky. Hence phase shift oscillators make use of 3 RC sections in which each section provides a phase shift of 60 degree. The latter is generally used in high precision applications where cost is not much regarded and only accuracy plays a major role.
A phase-shift oscillator is a simple electronic oscillator circuit. It consists of an inverting amplifier element such as a transistor or op amp, with its output fed back into its input through an filterconsisting of a network of resistors and capacitors. The feddback network 'shifts' the phase of the amplifier output by 180 degrees at the oscillation frequency, to give positive feedback.[1] Phase shift oscillators are mostly used at lower frequencies, often in the audio frequency range as audio oscillators.
DISADVANTAGES OF RC PHASE SHIFT OSCILLATOR.1. The output is small due to smaller feedback. 2. It is difficult for the Circuit to start oscillations.3. The Frequency stability is not so Good.4. It requires high Vcc. For large feedback.