Current Transformers are used to measure electric currents. When current in a circuit is too high to directly apply to measuring instruments, a current transformer produces a reduced current accurately proportional to the current in the circuit, which can be conveniently connected to measuring and recording instruments.
To calculate the no load current from transformer & core loss is also calculated.
To limit the current flowing through the primary circuit.
Transformers are not intended to be operated in DC. DC does not provide the continuously fluctuating current that a transformer requires in order to function. On DC, a transformer will act as a transient mode inductor, and settle out to a high current state, destroying itself.
I am assuming the question is about the power / distribution transformer and not the current transformer. The primary current is a function of load connected on secondary. With the open secondary, there is no load, no current, it is open circuit. Hence no primary current. However there is always some small amount of no load current in the primary winding.
in welding machine, the transformer used is basically a current transforrmer. so by changing the tap of secondary side of transformer, we can increase or decrease the current in the transformer.
use of CT
When the secondary of a transformer is opened, there is no longer any load on the transformer. There will be some current flowing in the primary winding, which is needed to induce the voltage in the secondary. This primary current is referred to as the "no load" current, and is indicative of the core losses in the transformer.
To calculate the no load current from transformer & core loss is also calculated.
To limit the current flowing through the primary circuit.
The function of fans in a transformer is to regulate the transformer's temperature.
The basic function of a transformer is to change voltage levels.
The function of the radiator ban in a transformer is to cool the transformer oil.
Transformers are not intended to be operated in DC. DC does not provide the continuously fluctuating current that a transformer requires in order to function. On DC, a transformer will act as a transient mode inductor, and settle out to a high current state, destroying itself.
I am assuming the question is about the power / distribution transformer and not the current transformer. The primary current is a function of load connected on secondary. With the open secondary, there is no load, no current, it is open circuit. Hence no primary current. However there is always some small amount of no load current in the primary winding.
in welding machine, the transformer used is basically a current transforrmer. so by changing the tap of secondary side of transformer, we can increase or decrease the current in the transformer.
why does have to short-circuit secondary wire of current transformer ?
The difference between current transformer and potential transformer is that the secondary of a current transformer can not be open circuited while under service whereas that of the potential transformer an be open circuited without any damage to the transformer.