To carry the electric power to a light . . OR . . it's wire that is not too heavy to carry.
A 'live' or 'hot' wire is a wire that is connected to a power source. This wire supplies voltage to a load ( light bulb, hair dryer, etc.). When the load is also connected a neutral or another live wire this becomes a path for the flow of current (amps) known as a circuit.
They are for stripping the insulation off electrical wire.
You put switch in series with the black supply wire and the black wire to the first light. Then connect black wire of first light to black wire of second light, black wire of second light to third light and so forth. Do the same with the white wires and ground wires.
The green wire on the light fixture is a ground wire. If there is no ground wire in the conduit, the green wire should be attached to the metal box with a screw.
with a standard 1 pole light switch (one switch operating the light) it is black wire to black wire and white to white (non grounded)
A light wire is probably a wire with light in it, but to be honest, I haven't really heard of it. lol
That truck came equipped with a license plate light, so there should be a wire present for that function. Look for a disconnected wire behind the rear bumper. The wire would be live when the head lights are on. Connect a new light and make sure it is properly grounded.
A 'live' or 'hot' wire is a wire that is connected to a power source. This wire supplies voltage to a load ( light bulb, hair dryer, etc.). When the load is also connected a neutral or another live wire this becomes a path for the flow of current (amps) known as a circuit.
first of all, you need a bulb, a wire, and ONE light bulb. You clip the wire on the battery and touch the wire on the bottom of the light bulb
A 'live' or 'hot' wire is a wire that is connected to a power source. This wire supplies voltage to a load ( light bulb, hair dryer, etc.). When the load is also connected a neutral or another live wire this becomes a path for the flow of current (amps) known as a circuit.
They are for stripping the insulation off electrical wire.
You put switch in series with the black supply wire and the black wire to the first light. Then connect black wire of first light to black wire of second light, black wire of second light to third light and so forth. Do the same with the white wires and ground wires.
The green wire on the light fixture is a ground wire. If there is no ground wire in the conduit, the green wire should be attached to the metal box with a screw.
In an incandescent light bulb the wire that gives off the light is called the Filament.
with a standard 1 pole light switch (one switch operating the light) it is black wire to black wire and white to white (non grounded)
It has the same function as braces, but is only a wire. Like a retainer.
They are for stripping the insulation off electrical wire.