0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the hourly fuel consumption of a Cat 315 Excavator?
On full throttle it uses about 4 gallons per hour. Or 30-35 gallons in 8 hours on the hour meter.
What is the hourly fuel consumption of a 330 cat excavator?
The average fuel consumption of Cat 330 varies from 25 - 35 liter / hour depend on the type of work
How about fuel consumption of Toyota Avenza?
15.8 kl or around 35 mpg.
What is the fuel consumption for toyota spacio xg edition?
Fuel consumption for the Toyota Spacio XG Edition is approximately 35 miles per gallon. It is a seven passenger vehicle.
What was the hourly wage in 1944?
35 cents
What was average hourly wage in 1920?
.20 per hour
What is the average fuel economy of the Nissan Stagea?
In general, the average fuel consumption of the Nissan Stagea rests in the 35 - 40 miles per gallon range. Many of these cars exceed this value and can reach about 48 miles per gallon.
What is the average hourly rate in Arizona for a Nurse Practitioner?
35-45 hr depending on experience
Union painters hourly wage in New York City what is the hourly wage of a union painter in New York City?
nyc dc 9 painters union.....$35 per hour
What is the average hourly rate for a licensed electrician in Edmonton Alberta?
$27-$35 per hour
What is the average hourly raye for a licensed master electrician in the rochester ny area?
The average hourly rate is around 35 dollars an hour. Electricians that are very experienced, can make even more money.
How is fuel consumption on a ship calculated?
I believe it would be either gallons per hour or tons (of fuel) per hour. Well ships vary in their sizes and so does the fuel consumption. As i have been sailing for last 10 years, ive seen ships consumtion of oil ranging from 35 tons/day to 110 tons/day. Fuel consumption on board ship is by taking flowmeters which are installed on the fuel oil line going to the engines. The reading is taken everyday or after some maneuvering is being done. The difference in the reading gives the amount of fuel in litres consumed. This quantiry in leters when multiplied with the temperature correction factor and then converted into mass by multiplying with the density of fuel Hence we get the fuel consumed per day. To make sure the calculations are going fine..at regular intervals the quantiry remaining in the fuel tanks is being checked and functioning of flowmeters along with any accidental seepage is confirmed.
