52 1/2 in with an 8.2 rear with 8.5 you need 51 1/2 we found out the hard way the 8.5 case is 1 in longer
YES it will bolt right up. BUT you will probley have to modify the driveshaft length. Front yoke for sure.
Yes, you can replace a Turbo 350 transmission with a Turbo 400 transmission, but there are some considerations. The Turbo 400 is larger and heavier, so you may need to modify the transmission crossmember and possibly the driveshaft. Additionally, you'll need to ensure compatibility with your vehicle's engine and adjust the shift linkage. Always consult a professional or detailed guides specific to your vehicle for the best results.
The splines on the transmissions were the driveshaft slides into are different on the 350 and 400 turbo's So that means you will have to change the yoke on the end of the driveshaft.
no .. transmissions are reversed..
The bell housing pattern is the same, but the front driveshaft yoke is different. Driveshaft length is probably different. Might need to move the tail shaft mount. Not sure how to deal with the speedometer cable and kickdown, but an online retailer like Summit or Jeg's would likely be able to sell you what you need.
Yes, The 350 turbo is the standard trans in that model, 85 caprice's usally don't have a manual installed from the factory, nor do most hot rodders put one in, not to my knowlege. It is possible that the car could have had a turbo 400, a upgrade option, which has different tailshaft housing, which makes the tranny mount and the driveshaft differ from the 350 mounts and driveshaft length. jr
It is 27 inches long.
No, a 4L60 transmission cannot directly interchange with a Turbo 400 transmission. The 4L60 is an electronically controlled four-speed automatic transmission, while the Turbo 400 is a three-speed automatic transmission with a different design and shift pattern. Additionally, the mounting points, bellhousing, and driveshaft configurations differ between the two, requiring significant modifications for an interchange.
yes
Yes but the transmission will blow you need a racing 350 transmission
Yes, a Turbo 350 transmission can be swapped out for a 700R4, but it requires some modifications. The 700R4 is a more complex transmission with overdrive, which means you'll need to address differences in the mounting points, driveshaft length, and possibly the transmission crossmember. Additionally, you'll need to account for the electronic components and adjustments for the kickdown cable. Overall, while it's feasible, it may require significant work to make it fit properly.
I have a 350 turbo in mine Just about any transmission will work! Powerglide, Turbo 350 (lockup or non) or Turbo 400, even 700r4.