Muriatic acid is a very strong acid. The pH will vary depending on the concentration of the acid. A 10% concentration (by weight) has a pH of around -0.5 while a 38% concentration has a pH of around -1.1. I found this information at: http://en.wikipedia.org/wiki/Muriatic_acid.
liquid muriatic acid
The pH level of a pool can be lowered by using a specific acid that is sold at pool supply stores. The acid is called muriatic acid, and it should be added to the pool while the water is circulating. About 1/4 gallon of the muriatic should be added per .1 part per million the pH needs to be lowered.
If the pool is too acidic, pH is low, add soda ash (sodium carbonate). If it is too alkaline, pH is high, add muriatic acid.
Muratic acid (Hydrogen Chloride) at a 10% concentration has a PH of -.5. This is the concentration that is available for most houshold uses.
The pH level for acetic acid is 3... The pH level for acetic acid is 3...
liquid muriatic acid
acid can dissolve wood with its high chemiacal ph level
Yes, muriatic acid is just hydrochloric acid.
The pH level of a pool can be lowered by using a specific acid that is sold at pool supply stores. The acid is called muriatic acid, and it should be added to the pool while the water is circulating. About 1/4 gallon of the muriatic should be added per .1 part per million the pH needs to be lowered.
Lower pH by adding muriatic acid.
It depends on the pH level in the pool and the gallons of the pools, also how many ppm you want to lower it.
I tried both types of acid. The pH Minus (dry acid) and then the muriatic acid. I did not have much luck at all with the total alkalinity (TA) dropping with the dry acid. When I used the muriatic acid the TA dropped within a couple of days. So to answer your question I'd have to say the muriatic acid. It is much cheaper ($12 a case) at Leslie's Pool Supply and probably cheaper other places. The muriatic acid was also quicker and had better results.
Yes, you can use muriatic acid to control pH in a pebbletec pool. Added correctly (spread around the pool with circulation equipment operating) muriatic acid will not harm the pool. As a matter of fact muriatic or hydrachloric is the best thing to use but I suggest you dilute it 4 parts water 1 part acid for safety to you and your equipment
HCl in the stomach is (around 0.5%) and a pH of 1-2. You will need to make a solution of muriatic acid similar to that. If you have pH paper, you can figure it out.
Muriatic Acid....Be real careful though.
If the pool is too acidic, pH is low, add soda ash (sodium carbonate). If it is too alkaline, pH is high, add muriatic acid.
Very small amounts of muriatic acid are mixed with water to lower the pH balance of the water and make it suitable for water pine trees. It is important to be careful and test the pH balance of the water because too much muriatic acid will kill the trees.