That would be the POINT OF CONVERGENCE.
it is called the vertex
They form angles.
The origin.
Change to a different process. MIG welding ALWAYS, always, always creates spatter. How you stop excessive spatter is by adjusting the voltage and wire speed. Lower voltage and faster wire speed = more spatter. Higher voltage and lower wire speed = less spatter. How you find the magic combination for the weld you are making is to test in an inconspicuous place - run a bead, check for spatter, adjust the two settings, run another bead...eventually you will get to the point where you're getting a nice weld with an acceptable amount of spatter, and then you weld your project with it.
angles around a point.
perpendicular lines
It matters about how the lines intersect. If they intersect like this: +, then the point of intersection is called a perpendicular intersection. If the corners do not have right angles and the angles are obtuse and acute, then it is called intersecting lines. Glad to help!almost.
The lines are called perpendicular lines.
Yes and the angles around the point of intersection add up to 360 degrees.
The bisectors of the angles of a triangle are concurrent at a point called the incentre which is also the centre of the inscribed circle that touches all three sides.
Vertical opposite equal angles are then formed
Systolic