If the Strut Bar is a GM Performance Parts Strut Bar then you have to purchase a set of end brackets. The same front strut bar can be mounted to the rear with a set of rear strut brackets. http://drcustomparts.com/HomePage.htm More info at w-body.com
the same as every strut mount. to hold the struts
FRONT STRUT: Damper Shaft Nut >52 Ft-lbs, Strut Upper Mounting Nuts >24 Ft-lbs, Strut to Steering Knuckle Nuts >96 Ft-lbs; REAR STRUT: Damper Shaft Nut >55 Ft-lbs, Strut Upper Mounting Nuts >33 Ft-lbs, Strut to Rear Knuckle Nuts >89 Ft-lbs.....
remove the rear wheel, undo the bottom bolt of the strut. inside the car remove the plasic paneling in the back covering the strut mount. unscrew both nuts and pull the strut out.
Front: Strut to body: 29-40 ft. lbs. Front: Strut to knuckle: 84-98 ft. lb.s Rear: Strut to body: 12-14 ft. lb.s Rear: strut to knuckle: 65-80 ft. lb.s
Your vehicle is equipped with struts. Answer Provided By Freeautomechanic.com == To Remove: # Remove the three upper strut-to-body mounting nuts. # Raise and safely support the vehicle. # Remove the rear tire and wheel. # Disconnect the stabilizer bar link from the strut. # Scribe the strut to the knuckle so it can be installed in the original position. # Support the knuckle and hub and then remove the strut to knuckle bolts. # Remove the strut from the vehicle. To Install: Rear strut assembly removal/installation # Position the strut on the rear suspension. # Install the strut to knuckle bolts. Tighten the bolts to 90 lb ft (122 Nm). # Connect the stabilizer bar link to the strut. # Install the tire and wheel assembly. # Install the three upper strut mounting nuts. Tighten the nuts to 30 lb ft (41 Nm). # Lower the vehicle. # Check and adjust the rear wheel alignment if necessary.
YES A Rendezvous does has a shock and a strut on the rear.
A link with more information on this process can be found in related links.
The rear struts can be removed, on your 2005 Toyota Camry, by removing the nuts on each end of the strut. With the nuts removed the strut should slide off of the stud.
The Chrysler 300 rear struts are held in place with a retaining bolt on each end of the strut. Remove the retaining bolts and the strut will come off. Reverse the process to install the new rear struts.
inside the trunk?
The rear struts can be removed, on your 2005 Toyota Camry, by removing the nuts on each end of the strut. With the nuts removed the strut should slide off of the stud.