What is the purpose of using the copy tftp flash command on a router? to back up the current IOS image to a server to restore the IOS image from a server to back up the router configuration to a server to restore the router configuration from flash
Router#copy tftp run
This is an incomplete command. However, this indicates that the running configuration will be saved on the device to a different location.
no router is a network device using router only we can connect to different networks in a LAN so the answer is CPU.
Run them both together using lan cables into the router.
The purpose of using monitoring systems is to capture data. Another purpose of using monitoring systems is to monitor the environment for security purpose.
A router. The key word is create. you can not create a domain using a switch, repeater, or hub.
ping test
NVRAM
Router provide the best way to data to travel.
This is an incomplete command. However, this indicates that the running configuration will be saved on the device to a different location.
The difference between an N and a G router is all in what the purpose of your router is for. You need to see if you are using it for a personal or business use.
It disables nonessential system processes and services.
Assuming you have a Cisco router, you add a static route with the command ip route.... Therefore, you delete it with the command no ip route....Assuming you have a Cisco router, you add a static route with the command ip route.... Therefore, you delete it with the command no ip route....Assuming you have a Cisco router, you add a static route with the command ip route.... Therefore, you delete it with the command no ip route....Assuming you have a Cisco router, you add a static route with the command ip route.... Therefore, you delete it with the command no ip route....
The interface is configured as a DCE device.
Yes, if your firewall has allowed connections from the router then you can find the IP. I am assuming you are using Windows you can open command prompt > type 'ipconfig' > then find the IP for the router. Then in your address bar in a web browser paste this IP in.
To start the specified network service.
router(config-if)#
CCNA Guide to Cisco Networking Fourth Edition Ch.8 Answer: OSPF is configured using the router ospf [process id] command.