Want this question answered?
That's called the frequency.
Time dilation, which can be derived from the Lorentz transformations is t'=t/sqrt(1-v^2/c^2) where t is the time interval in the rest frame, and t' is the interval in the lab frame. This relationship is neither linear or exponential in v.
Wavelength, λ, and Frequency, f, are inversely proportional. Their product is a constant, the wave velocity. For lightwaves, their product is the speed of light, c: c = λ * f = 299,792,458 m/s, ~= 3.00 * 10**8 m/s, 0.300 m/ns, 30.0 cm/ns, ~= 186,000 mi/s, 11.811 in/ns, 0.984252 ft/ns; Where ns = nanoseconds, or 10**-9 seconds. Frequency, f, and Wavelength, λ, describe simple values that can be measured on a moving wave, if it contains a constant signal or, at least, a clearly repetitive waveform. So, as the wave moves past a reference point like a microphone, or radio receiver, find some repetition in the wave, measure the shortest interval of time, t, that marks the entire repetition. The frequency, f, is simply[1] the reciprocal of that time interval: f = 1 / t The wavelength is the measured distance between two identical areas of the waveform (like peaks, troughs, or blips), in adjacent copies of a repeating waveform. Whereas the interval measurements required one wave sensor, plus a fast timer, the wavelength measurements require two wave sensors, accurate distance measurements, but no timer. As the sensors are separated, the two signals will diverge until, at one wavelength separation, the two signals become identical again (difference is minimal). Sometimes, it is hard to be highly accurate about where, exactly, a single interval starts and stops. However, if you can flawlessly count a large number of repetitions, just do your best to start and stop the timer in the same place on the first and last repetition. Now you get to multiply your accuracy! Divide the total time, Δt, by the number of intervals, n, this average is an improved measurement of interval! t = Δt / n If you divide the count by the time interval, you get an improved frequency measurement. [1] Frequency is a counted number, n, of full waveform repetitions divided by the total elapsed time, Δt. f = n / Δt
Interval between expiration and inspiration
Acceleration has two parts ... its size and its direction.To find the size (magnitude):-- pick a time interval-- measure the speed at the beginning of the interval-- measure the speed at the end of the interval-- subtract the speed at the beginning from the speed at the end-- divide that difference by the length of the time interval-- the result is the magnitude of acceleration during that time interval
Called an interspike interval
CLASS
Frequency
Yes.
histogram
banana
the interval's frequency is stored in the controls interval property , which specifies the length of time in milliseconds.
the interval's frequency is stored in the controls interval property , which specifies the length of time in milliseconds.
a specific point mark or degree
equal groups on the table which is the scale
frequency
basically this is an exampleAGE (YEARS) FREQUENCY FREQUENCY DENSITYFD= Frequency DensityAge : 0