Transformer works on the principle of Electromagnetic induction.
A transformer is an electrical device that takes electricity of one voltage and changes it into another voltage.
Transformers don't work with DC supplies - they only work on AC.
No. From what you're saying you're taking the input to the 2kV transformer in a microwave and replacing it with a 1MW input. The transformer will burn in milliseconds of power. <<>> The installation and maintenance of a 1000 KVA transformer can be worked on in a de energized state. To do so live could be extremely dangerous at any voltage.
A stp-down transformer steps voltage down from a high value to a low value. Transformers only work with AC.
major component of power loss in a transformer is secondary resistance.when transformer is operated under no load,no current flows through the secondary.so under no load conditions transformer has just very small megnetic losses.
One transformer should feed several led's in parallel, but you have to work out how much current each one will take, total it up, and then get a transformer with the correct output voltage and that can supply the total current. Don't exceed the transformer max current or it may fail through overheating
transformer will work on ac
The Bicepticons
The working of a transformer depends on the Faraday Law of Electromagnetic Induction.
yes
No. A transformer has to have AC, alternating current, to work. And since it's alternating, it'll have a frequency.
Its transformed into work!
A transformer is an electrical device that takes electricity of one voltage and changes it into another voltage.
Find the wire from the secondary of the transformer. If it's a step-down transformer the thicker wire is the secondary. Measure its diameter in inches and calculate its cross-section area in square inches. The current rating for transformer wire is 1000 amps per square inch, or 1.55 amps per square mm.
No
hthhrhr
What is the definition of earthing and how it works?