5'8" from the floor to the CENTER of the BULLSEYE is the height. 7'9.25" from the FACE of the board is the throw line.
the dartboard center (bull) must be fixed at 1.73 mt ; then set the throw line at 2.37 form dartboard
25,000,000 km from the ground
you need a really big house btw alright?
have fun with hanging your new dartboard!
your welcome for me telling you!
from the floor to centre bulls eyes it is 5 feet 8 inches or 173 centimetres
The height of a regulation dartboard is 5'8" from the center of the bullseye to the floor, with a toe line at 7' 9.5" inches from the front of the board for steel tip darts.
A dartboard manufactured by Widdy is an American style board, usually found around Philadelphia and that region. This is opposed to an English style board.An American board has both the double and triple scoring rings on the outside. It also has thin inlaid steel wires separating the sections. This differs from the English board that most people know, which has the double ring on the outside, and the triple ring halfway between the cork and outer ring. For an English style board, the official measure is "center of the bullseye is 5 feet 8 inches from the ground." However, for American style boards like your Widdy, 5'3" is the correct height. See this blowup:http://www.americanstyledarts.com/widdyDistanceBlowup.htmlthe height has the same measurements as the width.
It depends what kind of conference you are going to. If it is your average board meeting, the yey high. If it is a clown conference, then hey high, but if it is a dwarf conference, the you're best off just sitting on the floor.
The common US distance from throw line to face of board for soft tip darts is 8 feet. 7'-9.25 inches is for steel tip darts.
First you need to buy or build a dart board cabinet. When you hang the dart board cabinet you want to make sure that when you put the dart board inside the bullseye is 5' 8" high.
The height of a regulation dartboard is 5'8" from the center of the bullseye to the floor, with a toe line at 7' 9.5" inches from the front of the board for steel tip darts.
The bullseye is red
The bullseye should be about 5 feet 8 inches from the ground. The throwing distance is also about 9 feet 9 inches.
5 feet 8 inches Standard height from the floor to the bullseye on the dartboard is 5 feet 8 inches, while the oche (distance between the front of the board and the toeline) should measure 7 feet 9.25inches.
A standard toe board shall be a minimum of four inches nominal in vertical height from its top edge to the level of the floor, platform, runway, or ramp.
From the throwing line to the surface of the board 2,37m (measured parallel to the ground). The height of the bullseye 1,73m.
5 feet & 8 inches from the floor to the centre of the bullseye. 7Feet 9 and a quarter inches from the face of the board to the throw line or "oche" For Soft tip darts 8 feet from the face of the board to the throw line or "oche"
2.5 inches
It is 96 inches by 32 inches.
The Bullseye must be exactly 5 feet 8 inches from the floor and the toe line (where you stand to throw the darts) is 7 feet 9 and 1/4 inches from the board. Also see http://www.indepthinfo.com/darts/setup.shtml
the outer bull
The bullseye.