0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is inch tape?
The standard width of tape - it measures one inch across. Other common sizes are 1/2" (12mm) or 2" (50mm)
When two lanes merge into one and there is a collision who is at fault?
The lane that goes straight through without changing is the main lane. If you merge into that lane, you have to yield to the flow of traffic. That means if your lane ends, it is you that should yeild.
The angle through which max power is genereated is called beam width?
Sounds like you're talking about the main lobe of a radio antenna.It's kind of sloppy to say that the "max" extends across some width, since the "max"only happens in one single, specific direction.The "beam-width" is also often referred to as the "3dB beam-width". It's the angle betweenthe two points where the power is 3 dB less than the max ... one point on each side of the max.
What is one different way to to find the perimeter of a rectangle?
Length + length + width + width = perimeter. Length + width x 2 = perimeter
How do you determine if rectangles are Simular?
If the 'ratio' (length/width) of one rectangle is the same number as (length/width) of the other one, then the two rectangles are similar.
What is the width of a India highway lane?
The width of one lane for a two-lane highway (one lane each way) is at least 3.75 m (12.3 feet).For four-lane highways, the width of each lane, excluding shoulders, is at least 3.5 m (11.5 feet)
How wide is a lane in a lane mile?
A typical lane width is considered to be 12ft but does vary depending on the type of road and the location as some municipalities may vary.While the U.S. Department of Transportation maintains a breakdown of statistics for the lane widths of Interstate & arterial roads that deviate from the 12ft standard, most highway departments simply measure a Lane Mile as a single lane running for 5280ft, regardless of the width. Obviously if you are calculating to precise measurements, such as the number of square feet, you would either need to do some averaging, or have an extremely large supply of very rugged tape measures.
What is the Standard width of single car garage door?
8 or 9 foot, either one is common.
How long is each lane in a standard Olympic sized track?
From the staggered start, it is 400 meters around. The stagger is calculated by subtracting the extra distance one goes around a wider diameter. For each lane it is double the lane width (which in the Olympics is 1.22m) times pi. for each additional lane.
What is the width of aluminum foil?
In the UK the standard width is 30cm (one foot), and wide width is 45cm (a foot and a half).
What was the beatles 17th number one single?
penny lane
What is the standard size of a lane for 25m pool?
one of many lanes in a competition pool is about 10 feet wide. though I have been in one lane pools of 8 foot width that work just fine. one reason for the extra width in the multi lane pool is that when in heavy use, there is some overlap of hands/arms and the width is useful to avoid collision. also, during competition, the lanes are wide so that swimmers cannot draft off of one another. hope this helps aloha
What is the average width of a rural two lane road?
The average width of a rural two-lane road is typically between 20 to 24 feet. This width allows for two lanes of traffic, one in each direction, with enough room for vehicles to safely pass each other.
What is column width?
Column width is what it says -- how wide the column is.
What is single dimension?
One dimension: Length Two dimensions: Length, Width Three dimensions: Length, Width, Height
How far around a running track in lane 2?
A little more than 400 meters. To be more precise, the line you run around in a track which has an inside lane of 400 metres, and lane width of 1.27 metres including one lane marking, is 407.980 metres.
What is the width of a lane of a running track?
24'
