String 82
Cable 39 3/8
To answer this question the voltage of the genset is needed.
With a constant voltage and increase in wire length will increase the end to end resistance and therefore the current will decrease.
The length of the cable is determined by the distance from the center of the distribution panel to the center of the load.
The insulation resistance remains the same throughout the entire length of the conductor.
The type of cable that has a maximum length of 607 feet is the Category 5e (Cat 5e) Ethernet cable. While Ethernet cables can technically run longer distances, the standard maximum length for effective data transmission is 328 feet (100 meters). However, for certain applications, such as specific types of fiber optic setups, a fiber optic cable can transmit data over significantly longer distances, but that would not be applicable to traditional copper cables like Cat 5e.
Bear says bow string length is 86.125in & buss cable length 31in
what is the string length of a Mathew Mission compound bow
String is 98.5 and cable is 41.5 It varies by draw length, this is for 28" draw
I believe string length and cable length aren't 2 different things I can't seem to get a answer
The Jennings Lasermaster typically features a string length of approximately 60 inches. The cable length can vary depending on the specific setup and configuration, but it generally measures around 28 inches. Always refer to the manufacturer's specifications or documentation for precise measurements tailored to your particular model.
Mathew Feather lite String is 94 15/16 Cable is 40 3/16
No, you cannot. The shorter connection will not fit the string/cable. Even if it did, the tension could damage the bow.
Simple do a search on " USB cable" find the correct length you need and order it on line of go to a store that sells computers . to get the correct length, run an extension cord, string or wire from the beginning to the end , then mark it pull it out and then measure it ! bingo you are in business .......
1) Disconnect the antenna lead from the back of the radio 2) Tie a string around the end of the antenna wire that you just removed (make sure it is at least 4-5 feet in length 3) Remove the screws from the antenna mast mounting and pull out the antenna and cable with the string attached to it 4) Untie the string from around the end of the old cable and tie it to the end of the new cable 5) feed the end of the new cable into the mast mounting and, using the string inside the car, pull the new cable down through the pillar 6) Un-tie the string and plug the end of the cable into the radio 7) Re-install the antenna mount with the screws and tighten securely
You can select the cable length in the option box.
A cable length is a unit of measurement equal to one tenth of a nautical mile.
Yes, Cable length is always printed on the cable wire. As I have recently checked cables of peterstechnology.com cable length was printed with ISI certification mark & it's company logo. So anyone can easily recognize the medical cable. Thank you