It depends on the type of material that the screw in made of. Also the threads in softer materials such as brass will 'strip' if over tightened.
nope. the 440 with six pack rods and a forged crank used a different amount of balance than a 440 with a cast crank. the 440 with a forged crank and normal rods was internally balanced and the 360 had a different balance as well.
it applies torque to fulfill its design capabiities
30% of 440= 30% * 440= 0.3 * 440= 132
75% of 440= 75% * 440= 0.75 * 440= 330
92% of 440= 92% * 440= 0.92 * 440= 404.8
You can tighten ANYTHING too tight. EVERY bolt and screw has a specific torque specification. Look up what the torque specs are for the balancer bolt on your engine and tighten it to the specification.
375
What is the torque specifications for Madza T 3000 engine
The Ford Ranger alternator bolt torque specification is dependent upon the year of the Ford Ranger. In general, the alternator bolt torque specification is 45 pounds.
The 1987 Kia 1.8 liter engine had bolt torque specification is 120 pounds. The camshaft bolt torque specification is 90 pounds.
The 1999 Pontiac cylinder head gasket bolt torque specification is 160 pounds. The intake manifold bolt torque specification is 90 pounds.
440 Nm
9ft pounds
intake manifold
what is the torque specifications for the intake bolts on a ford 4.2L?
The 1995 Toyota 3.0 liter engine main bearing torque specification is 160 pounds. The rod bearings torque specification is 120 pounds.
Ford CFord Cylinder Head Torque Specificationsylinder Head Torque Specifications