Alright I
i have a 4d32 deisel engine i change the cylinder gaskit i need to know how much foot pound to torque the bolts
what is the crange oil sele number 4d32
110HP @3500rpm, 3.5 litre engine, 4 cylinder. That's as much as i know. I assume torque would around 400Nm
mutmut
0.45 millimiter
It has 8
You may be able to find a free repair manual ebook for the Mitsubishi Canter 4D32 engine by searching on websites that offer automotive manuals or by checking forums and online communities dedicated to Mitsubishi vehicles. However, be cautious when downloading from unofficial sources to avoid potential malware or low-quality content. It may also be useful to contact Mitsubishi dealerships or authorized service centers for technical support and official manuals.
110hp
8 Litre
how about timing gear
Metric - inlet and exhaust .15 (engine cold) .25 (engine warm)
I have the manual on the 4D32 engine. There are two sets of timing marks on the 4D32 engine. One set is marked 1-4 these are used on the bottom of the crank, the other is marked 2-3 and these are used on the top of the crank. The easiest way to time the engine is to remove the valve cover and turn the engine to the 0 degree. It was easier for me to use the bottom timing marks. When on 0 degree, at top dead center, both valves wil be closed. If you can not move the lifters, rotate the engine one revolution and stop on 0 degree. You should be able to move the lifters. Now find the notched gear tooth on the injector pump. One tooth has the back edge cut on the the gear. There is a mark on the injector housing, at about 2 o"clock. Turn the notched tooth to the mark and start pushing the pump into place. As the pump gears engage the timing mark on the pump will move down the distance on one tooth. Bolt pump into place and timing should be correct.