Ideally the voltage regulation voltage of a transformer should be zero. It means when you change the load from no load to short circuit (theoretically, normally you don't want to burn the transformer windings) the output voltage doesn't change and remains equal to the no load voltage.
'Zero voltage regulation' indicates that there is no difference between its 'no-load voltage' and its 'full-load voltage' -this is only the case for an 'ideal' transformer.
For an ideal transformer, the voltage ratio is the same as its turns ratio.
The lower the impedance, the lower the voltage drop across the transformer as it is loaded. This means regulation is better, since voltage variance is smaller.
depending on the amount of the load of transformer as well as the power factor of it, there is a transformer specific voltage drop at its terminals, due to the internal impedances. The on-load tap changer can / will be used to compensate this voltage drop or rise.
Transformer voltage regulation and size of the circuit breakers have no direct relation
'Zero voltage regulation' indicates that there is no difference between its 'no-load voltage' and its 'full-load voltage' -this is only the case for an 'ideal' transformer.
The change in output voltage from no load to full load defines the voltage regulation of that transformer.
A transformer will operate with a voltage regulation of zero when it is not supplying a load.
A transformer will operate with a voltage regulation of zero when it is not supplying a load.
For an ideal transformer, the voltage ratio is the same as its turns ratio.
The lower the impedance, the lower the voltage drop across the transformer as it is loaded. This means regulation is better, since voltage variance is smaller.
The lower the impedance, the lower the voltage drop across the transformer as it is loaded. This means regulation is better, since voltage variance is smaller.
Regulation of transformer means percentage reduction of transformer secondary voltage due to transformer loading as compared to its no load voltage.Another AnswerA transformer's voltage regulation is defined as 'the change in its secondary voltage, from no-load to full-load, at a specified power factor, expressed as a percentage of its full-load voltage, with the primary supply voltage held constant'.
what are zenar folloyars?explin with circute diagram.
The properties of an 'ideal' transformer are (1) voltage ratio equals turns ration, (2) no losses.
zero volatge regulation means the terminal volatge of transformer at full load on a given power factor become equal to the rated teriminal volatge of transformer , it happens only for leading power factor in transformer
depending on the amount of the load of transformer as well as the power factor of it, there is a transformer specific voltage drop at its terminals, due to the internal impedances. The on-load tap changer can / will be used to compensate this voltage drop or rise.