J C Higgins Firearms
Math and Arithmetic
Geometry

What kind of base mounts are needed for a JC Higgins 22 cal rifle Model 10313 that has two pairs of tapped screw holes on the side of the bolt housing and chamber?

141516

Top Answer
User Avatar
Wiki User
Answered
2007-06-20 01:48:59
2007-06-20 01:48:59

That gun was made by Marlin for Sears, and those holes are not factory. Someone has drilled and tapped it for (probably) a Weaver side-mount base.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


It depends on the exact model to which you are referring. Earlier models had three engine mounts; later models used four. If you are not comfortable or familiar with changing engine mounts, your best bet is to see an authorized mechanic, who can do the work needed.

The spring brake chamber is designed as a parking brake only. The service brake chamber is air operated which can be controlled more efficiently as needed.

There are more than a few J. C. Higgins marked shotguns and values vary by model. More information is needed in order to provide an answer.

No special preparation is needed to use a hyperbaric chamber other than educating patients about what to expect during treatment.

2, a left and a right. No, an Acura 2.5 TL has four engine mounts. A left and a right hydraulic mount located in the engine compartment, at the middle of the engine and two more mounts under the car bolted to the front of the transmission. The last two should really be called transmission mounts but they are listed and sold as motor mounts. The two front mounts cost at least $350.00 EACH!! The other mounts cost at least $50.00 each. I have worked on a few of these cars and every one had bad front hydraulic mounts. Some had all four mounts that needed to be replaced. Honda/Acura not as good as many of the other cars including domestic.

The highest average level of income needed to qualify for low income housing is $15,000 if I am not mistaken. I know that if you cannot be a college student if you plan to apply to live in them.

A common innovation after WWII was housing developments (tract housing); following the war, thousands and thousands of families were formed and needed inexpensive housing. The housing developments lead to strip malls, which lead to shopping centers.

No, custom fabrication is needed. Get a civic if you want drop ins.

It does not matter where you are in your life, it is important to have people around that relate and will be there to help you out. Singles housing is the perfect way for you to add much needed support to your life.

The G3 rifle can chamber the 7.62x51 NATO cartridge, and it could chamber the .308 Winchester if it needed to. No other cartridges are compatible with this rifle.

The Chamberlain headed the Chamber. The Chamber was branch of government in charge of expenditures. Basically, he made sure the royal government's revenue, collected by the exchequer, went where it needed to go.

Drain the Caprice oil. Unbolt the pan and lower. If needed, raise the engine by using a jack and unbolting the engine mounts. Take out the pan and clean the old gasket from the pan and engine block. Reinstall the pan with a new gasket. Reconnect the motor mounts if needed then fill the engine with oil.

See the housing links at http://www.geocities.com/bowieffa/poultry.html

Each city will have different low income housing rules. One should contact either the community center or a government official for the needed information.

The FE 352 cid ford motor has the same external dimension as all FE motors. Pre-1965 blocks (332, 361, 390, 427) have the same motor mounts. After 1965 engines have a different mounting holes, some machining/drilling would be needed, or custom motor mounts.

Senior housing usually offers some nursing help when needed. The buildings are built to be wheelchair accessible, have grab rails, and other safety features. One story housing is also common. Senior housing complexes often have common areas for activities.

It is important because They needed homes to survive. Women would often make woven mats for the houses and other certain housing materials were used.

Low income housing varies from state to state. Some states require people to qualify before they are considered, as there is tough competition to move in. Look in the classified sections of your local newspaper for cheap housing options.

Generally speaking, there is no such thing as emergency housing assistance through the voucher program. By federal law every housing authority must establish uniform criteria for qualifications to the program. It cannot allow bypassing of the waiting list, due to fairness of the program.

Drain the radiator into a suitable container. At the end of the upper radiator hose on the engine is the thermostat housing. Remove the 2 bolts and remove the housing. Remove the thermostat and clean both surfaces. Install the new thermostat and the housing. Service the radiator as needed.

That answer would be different sorts of valves which is made of tendons. I got that out of my science book, plus, we just learned about this about 2-3 months ago. I hope I really helped and got the answer you needed :)


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.