Any information that is within the line of path of the router or switch is the network information that you can glean from issuing commands on a router or switch.
DHCP which shows a pool if IP address
You can get information about ports, settings on each port, routing tables, filtering rules etc.
Paris(config)# router eigrp 100 Paris(config-router)# network 192.168.7.0 Paris(config-router)# network 192.168.8.0
it starts the routing protocols on interfaces It allows the router to advertise a network
The router will be unable to ping 192.168.1.2. The router has two interfaces that participate in the RIP process. The router will forward the updates for 192.168.1.0 on interface Serial0/0/1. The router is not originating routes for 172.16.1.0.
The TCP/IP information is supplied to any DHCP client on the network connected to the FastEthernet 0/0 interface of R1
router
Perhaps you mean a router?
routable
First you must decide what specific protocol you want to use. Then you configure it on the individual routers. Example, with Cisco routers: Router(config)#router rip Router(config-router)#network 10.0.0.0. Router(config-router)#exit Additional commands may be required for optimization. Note: I use RIP for illustration purposes, but it is usually not the best option for routing.First you must decide what specific protocol you want to use. Then you configure it on the individual routers. Example, with Cisco routers: Router(config)#router rip Router(config-router)#network 10.0.0.0. Router(config-router)#exit Additional commands may be required for optimization. Note: I use RIP for illustration purposes, but it is usually not the best option for routing.First you must decide what specific protocol you want to use. Then you configure it on the individual routers. Example, with Cisco routers: Router(config)#router rip Router(config-router)#network 10.0.0.0. Router(config-router)#exit Additional commands may be required for optimization. Note: I use RIP for illustration purposes, but it is usually not the best option for routing.First you must decide what specific protocol you want to use. Then you configure it on the individual routers. Example, with Cisco routers: Router(config)#router rip Router(config-router)#network 10.0.0.0. Router(config-router)#exit Additional commands may be required for optimization. Note: I use RIP for illustration purposes, but it is usually not the best option for routing.
AB
stub router.
Both are Department of Defense computer systems. NIPR is the Non-classified IP Router Network for sensitive but unclassified information. SIPR is the Secret Internet Protocol Router Network for secret or classified information.