Brake lines and/or clutch line depending on vehicle. For brakes, the front brake lines usually attach to the frontmost connection, and the rear brake lines attach to the rearmost connection. Also of note, the front brakes typically connect to the largest of the two master cylinder reservoirs (normally the front one).
It can be attached to the bottom of the master cylinder or on the drivers side frame between the firewall and the radiator. Follow the brake lines coming out of the master cylinder.
The brake lines are not attached to the booster. They are attached to the master cylinder. To remove them, use an opened end wrench on the fittings located where the lines meet the master cylinder and slowly turn counter clockwise. BE CAREFUL NOT TO STRIP THE FITTINGS THEY ARE MADE OF BRASS AND ARE VERY SOFT!
In order to replace the master cylinder with ABS attached to the master cylinder on a 1995 Grand Am you will need to complete the following steps: Disconnect the negative battery cable. Locate the master cylinder which is attached to the drivers side of the firewall. Remove the ABS brake line from the master cylinder using a wrench. Disconnect the fluid hose from the master cylinder using a wrench. Unscrew the nuts that hold the master cylinder in place. Remove the master cylinder and install a new one. Reattach the fluid hose to the master cylinder. Reattach the ABS brake line to the master cylinder. Tighten all the nuts and bolts and reconnect the negative battery cable.Once all of these steps have been completed you can be sure that your master cylinder has been properly replaced and is ready for use.
Good time to replace all the brake fluid. Remove the brake lines from the Master Cylinder and pump the master cylinder dry. Add fresh brake fluid from an unopened can and bleed the master cylinder. Reinstall the brake lines and then bleed all brake lines until you see clean fluid. Keep adding fluid to the Master Cylinder until you are done.Good time to replace all the brake fluid. Remove the brake lines from the Master Cylinder and pump the master cylinder dry. Add fresh brake fluid from an unopened can and bleed the master cylinder. Reinstall the brake lines and then bleed all brake lines until you see clean fluid. Keep adding fluid to the Master Cylinder until you are done.
Master Brake cylinder replaced and lines bled-how long?
Begin by removing the brake lines. Remove the master cylinder retaining bolts. The master cylinder will come off. Reverse the process to install a new master cylinder.
The ECU for the ABS brakes is attached to the Master cylinder for the brakes.
Looking from the front of the vehicle into the engine compartment it is on the right hand side attached the brake vacuum booster. The booster is the large round object about 8 inches in diamter and attached to the fire wall. The brake master cylinder will have a cup on top containing brake fluid and brake lines coming out of it.
The ECU for the ABS brakes is attached to the Master cylinder for the brakes.
It's attached to the master cylinder
The master cylinder.
Operates the brakes when the pedal is pressed. The pedal pushes the master cylinder, this pushes brake fluid down the brake lines, the fluid pushes the piston(s) in the wheel cylinder, the pistons push the pads or shoes onto the drum or rotor which is attached to the wheel.