0
A 1995 Ford Thunderbird is OBD I , EEC IV
What else can I help you with?
What transmission fluid do you use for a 1978 ford thunderbird?
Mercron transmission fluid is used in a 1978 Ford Thunderbird. Type F fluid can also be used but should not be mixed.
What type of freon is used in a 1995 Ford Used Air conditioner system?
R-134a
What transmission is in a 1995 Ford Thunderbird?
C-6 transmission has not been used for several years, since early 80's. What you have is an overdrive transmission 4R70W that is electronically controlled.
What was the car used in the Australian crawl music video reckless'?
Ford thunderbird
Did stu bailey ever drive a 1957 ford thunderbird in 77 sunset strip?
The 1957 Ford Thunderbird is one of the most prized cars out there. Yes, it was used during the show 77 Sunset Strip.
What kind of gas should i use fo my 4.6 thunderbird 96'?
According to the 1996 Ford Thunderbird Owner Guide : ( " regular " unleaded gasoline , 87 octane is used in your 4.6 )
What size rear end is used in the 1997 for thunderbird?
The 1997 Ford Thunderbird has a four bolt rear and. The rear and gear ratio is 3.23. The rear axle has a weight rating of 1600 pounds.
What kind of transmissions do the put in the 1995 Ford Explorer limited?
The automatic transmission used in the 1995 Ford Explorer is a ( 4R55E )
What cars were used in the Thunderbirds movie?
The FAB-1 is a custom concept designed and built by Ford Motor Company, based on the Ford Thunderbird. It was custom-made for the movie
What type of refrigerant is used in a 1990 Mercury Cougar and Ford Thunderbird?
R12, which is very expensive. Have it changed over to a newer refrigrant.
Will a 1992 Ford Explorers transmission fit in a 1995 Ford Explorer?
1995 was the first year an electronically controlled automatic transmission was used in the Ford Explorer ( I believe it was called the 4R55E ) In the 1992 Ford Explorer an A4LD automatic transmission was used
How do you replace ball joints on a 97 Ford Thunderbird?
The ball joints on a 97 Ford Thunderbird are replaced by placing the vehicle on jack stands, removing front wheel and rotor, and unbolting the steering knuckle. A ball joint puller is then used to remove the ball joint and a special installer tool is used to press the new one into place.
