answersLogoWhite

0

I used Gorilla Glue. It has worked for 2-3 years

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

What part do you need to hold the headlamp washer covers in place on your 2003 SAAB 9 5?

I used Gorilla Glue. It has worked for 2-3 years


How do you operate the headlamp washers on a 2003 gmc envoy?

To operate the headlamp washers on a 2003 GMC Envoy, ensure that the vehicle is equipped with this feature, as not all models may have it. If your Envoy has headlamp washers, they can typically be activated by pulling the windshield wiper control lever towards you. This action will spray washer fluid onto the headlights. Make sure the washer fluid reservoir is filled for the system to function properly.


How do you get at the headlamp bulbs of a 2003 Vauxhall Vectra 32L V6?

Bulbs are accessed from the rear of the headlamp units under the bonnet. To expose the bulbholders,you have to remove the battery cover,the inlet pipe to the air filter and the filler pipe to the washer reservoir.


What kind of bulb for headlamp for a 2003 eclipse?

they are H4


Where is fuse for washer pump in 2003 kia caren's?

location of washer pump 2003 kia sorento


How do you change a headlamp on a 2003 Chevy Malibu?

very carefully


Where is the windshield washer pump in a 2003 Pontiac Grand Am?

How do you change the windshield washer pump on a 2003 Pontiac Grand Am


How do you change a windshield washer pump on 2003 Buick Regal?

how to replace windsheild washer pump 2003 buick regal


How do you change nearside front headlamp bulb on mondeo 2003?

2 sliding bars hold headlight in remove and pull headlamp forward and out


How do you change a headlight bulb on a 2003 s-10 Chevy?

Standing in front of the bad headlamp, with the hood open, notice the two black tabs sticking up behind the headlamp assembly. These are locks that hold the headlamp assembly in place. Remove the locks by wiggling and pulling straight up. Now the headlamp assembly will drop out the front far enough to twist out the bulb socket to change the bulb. Reverse for installation.


How do you add washer fluid to the rear washer 2003 windstar?

According to the 2003 Ford Windstar owners manual : The washer fluid for the rear liftgate is supplied by the same reservoir as the front windshield


How do you remove the headlamp assembly on a 2003 Subaru Forester for changing the light bulbs inside the assembly?

I have a 1999 Forester, but I imagine the 2003 is similar in this regard. You don't actually need to remove the headlamp to replace the bulb. On my car, I unplug the wire from the bulb at the back of the headlamp, remove the large rubber piece around the back of the bulb, unclip the clips that hold the bulb in place, remove and replace. Cheers! Mark This is a good answer and is so just as stated. Thanks Mark! RicT