0
The exhaust side.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What is code 224 for 1994 ford ranger?
I believe that is ( PCM detected coil 1 , 2 , 3 , or 4 primary circuit failure - dual plug )
What is the plug gap for a 1996 Plymouth Neon?
0.035 for standard plugs. Single and dual cam.
How do you replace spark plugs in 2010 Ford Fusion?
How to replace spark plugs on a 2010 ford fusion
Where are the spark plugs located on a 2002 ford crown Victoria?
You should have C.O.P. ( coil on plug ) The plugs are under the coils.
How do you change spark plugs on a 1999 ford Crown Victoria?
If you have C.O.P ( coil on plug ) then the plugs are under there. Just remove the coil, pull the plug cap off and there you go.
How do you change the spark plugs on a 2000 ford crown Victoria?
Remove the coil on top of the plug. There's the spark plug.
How do you replace spark plug Ford Explorer?
The spark plugs on a Ford Explorer are replaced by first disconnecting the battery. Remove the spark plug using a spark plug socket. Replace with the factory recommended spark plug.
Why does a ford 300 6cyl motor have 12 spark plugs?
it not uses 12 spark plugs, it uses 24 sparks plug due that was the original design from ford's engineerings
Whats the difference between 1994 2.3 dual spark plug and 1988 2.3?
The difference is as follows; The 1988 Ford 2.3l came equipped with; -A cylinder head that housed a single spark plug per cylinder, and a "D" shaped intake port -A flat tappet camshaft -A distributor with Ford's TFI ignition system The 1994 Ford 2.3l dual plug came equipped with; -A cylinder head that housed 2 spark plugs per cylinder (both fire simultaneously in a typical "wasted spark" fashion), and a "swirl dam" intake port -A roller camshaft -Coil packs in place of the distributor, and a crankshaft position sensor housed inside the crankshaft pulley, commonly known as the "DIS" ignition system (distributorless ignition system) not to be confused with fords later "EDIS" system The switchover from single plug to dual plug 2.3l Fords were as follows; -1988 and older rangers are single plug -1989-1994 rangers are dual plug (1995-1998 2.3l dual plug rangers differ in many ways from the "early" dual plug engines) -1990 and older mustangs are single plug -1991-1993 mustangs are dual plug Note; 1989-1994 rangers & 1991-1993 mustangs share an identical engine for all practical purposes.
Can you replace an 8-plug ford eng.with a 4 plug engine?
Yes Leave 4 plugs out I found this the easy way to do it
How do you change spark plugs 1993 Ford Aerostar 3.0?
Changing spark plugs can be an easy task. Disconnect the battery and the spark plug cables, remove the old spark plugs, replace with the new spark plugs, connect the spark plug cables and the battery.
What is the correct spark plug gap for a 2000 ford escort zx2 2ltr?
According to the 2000 Ford Escort Owner Guide : For the 2.0 liter , Dual Over Head Cam , Zetec four cylinder engine : ( the spark plugs are gapped at .048 to .052 inch ) * confirm with the Vehicle Emission Control Information ( VECI ) decal located in the front of the engine compartment ( it will show what type of spark plugs to use and the spark plug gap )
