Probably around 40 psi Check with manual gauge - electrical gauge is just anguide and not gospel
Right by your oil filter
5w30
If that S10 has a 4.3 engine, I find it best to remove the distributor to gain better access to the oil pressure sensor.
I`m not sure if the swith is the same on a 2000 S10 but the 93`s have it mounted to the oil filter housing.I you.
The normal oil pressure on a 2002 Chevy S10 V6 is around 40 PSI. This will vary slightly depending on the temperature of the engine. Hot at idle in drive, 20 psi is also normal.
60 to 66 psi
At the rearmost section of the engine to the right of the distributor.
The oil capacity of a 1995 Chevy S10 V6 4.3L is 4.5 quarts when the oil filter is also changed. Oil levels should be checked with the dip stick to verify levels.
antifreeze leaks by the intake gasket into oil. deteriating bearings causing oil to leak by the bearing
I have owned three s10 two 6cy one 4cy they all ran at max on the gauges asked all my friends they all said it was right
Hot at idle, 20-30 psi.
The gauge should be electrical.