0
Don't soak it in any forms of water or else you motor won't work.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Why is your 1997 Chevy s10 arching up the tube on the coil back to the metal on the coil?
To much resistance in the spark plug wires, replace the spark plug wires.
Replace spark plug wires on 1999 grand marquis?
You should have C.O.P. ( coil on plug) there are no wires.
What causes a rotor button to burn up frequently?
To much resistance in the spark plug wires. Start fresh with a new distributor cap, rotor and spark plug wires. Also be sure you have the correct spark plugs installed.
Do you use resistor spark plugs with resistor wire plug ends?
No, Using a resistor spark plug with resistor wires can create too much resistance for the ignition system.
What resistance should a spark plug lead have?
14-16Kohm / metre
How do you change the spark plug wires on a 2000 Chrysler Concorde?
A 2000 Concorde does not have plug wires. There are individual coils on each spark plug.A 2000 Concorde does not have plug wires. There are individual coils on each spark plug.
Why are plug wires arcing through the boot?
The spark takes the path of least resistance. The boot may be old and cracked and/or the spark plug may be worn and has a large gap at the electrode.
Why would only one spark plug fire on a 1992 4.0?
try your coil pack, or distributor, if that doesent help test the resistance on the plug wires it should read around 13.0-16.0
How would you install spark wires on a 2003 miata?
You should never need to replace the wires leading to the spark plugs. The 2003 Miata has a coil pack at each spark plug (inside the spark plug hole). The wires leading to the coils are low voltage and should never break down.
How do you test spark plug wires?
Spark plug wires can go bad in several ways. They can develop shorts, or they can just build up resistance. To test for shorts, go out at night and open your hood and let your engine run. If you see little flashes, or hear pops, you probably have cracked wires that need to be replaces. To test for high resistance, you need a multimeter that can test for ohms (the resistance between two points.) You take off the spark plug wire and touch one probe of your multimeter to one end of the plug wire, and the other probe to the other end. Normal plug wire resistance should be 10,000 to 15,000 ohms per foot of length. If it is higher, it is probably bad.
What is the resistance of a cars spark plug since a spark plug is an open circuit?
The resistance measured under low voltage conditions should be infinite. High voltage ... like that that produces the spark ... behaves differently.
What voltage should you get at your spark plug wires?
that depends on the car and the brand of wires. you need to be more specific
