answersLogoWhite

0


Best Answer

According to the manufacturer:

* Front: 5-1/4" * Rear: 6" x 9" This will fit the 1996-1999 model years.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What size are the speakers of a 1999 Chevy Monte Carlo?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

1999 Chevy Monte Carlo?

Water pump removal chevy monte carlo 3.8


How do i replace the purge valve on a 1997 Chevy Monte Carlo?

How do i replace the purge valve on a 1999 Chevy Monte Carlo


Does a 1999 Chevy Monte Carlo have ABS?

They sure do.


1999 Chevy Monte Carlo charcoal canister location?

where is the vaccum canister located on a 96 monte carlo


1999 Chevy Monte Carlo z34 horsepower?

205 horsepower.


Will radio wire harness for 1999 Chevy Monte Carlo fit 2000 Monte Carlo?

I doubt it as they changed the body style in 2000.


Does a 1999 Chevy Monte Carlo has a emergency fuel cut off switch?

The 1999 Chevy Monte Carlo does have an emergency fuel cutoff switch. The emergency fuel cutoff switch can be found in the fuse box.


Can a replacement hood from a 1995 Monte Carlo fit a 1999 Monte Carlo?

Yes, there is virtually no difference in the dimensions and installation hardware of body parts between 1995-1999 Chevy Monte Carlos.


How do you change the timing cover gasket in a 1999 Chevy Monte Carlo LS 3.1?

video to learn how to replace the engine gasket..upper & lower gasket for 1999 Monte Carlo.


Where is the thermostat on a 99 Chevy Monte Carlo with a 3.1?

The thermostat on a 1999 Chevy Monte Carlo with a 3.1 is located just below the throttle body. It is covered by the top radiator hose attached at that location.


Where is the valve to recharge AC system located on a 1999 Chevy Monte Carlo?

The low side pressure port for the 1999 Monte Carlo should be on a pipe against the firewall. It is just to the left of the Dipstick.


How do you replace lug nut studs on a 1999 Chevy Monte Carlo?

How do you pull the wheel bearing assembly out from hub far enough to squeeze new lug nuts into place? The car is a 1999 Monte Carlo Z34.