Want this question answered?
You can't bypass with a belt alone. You have to by a bypass pulley kit. The new pulley takes the place of the ac compressor and you use the same size belt.
Size 6PK1675 does the trick
82.5 inch
I had a 1995 buick lesabre and the A/C compressor went out in the winter time. I waited until spring to replace the compressor. In the mean time, I used a Dayco 72.10 inch belt and bypassed the A/C compressor and it runs fine.
I t is either a 79 or an 85mm belt
There is an available bypass kit, but the belt is the same. You remove the ac compressor and install an idler pulley.
Other then finding a belt the right size, I don't see a problem.
It takes an 82 inch five grove belt.
2 feet
it would be a 5 by 6 belt for a magnum for a Lexus you would need a 3 by 7
Don't try to bypass the compressor by using a shorter belt. That will alter the belt wrap around the pulleys, which will result in slippage, squealing, and rapid belt wear. Go to www.dormanproducts.com and look up the part number for an A/C bypass pulley and then call your local auto parts store to check stock. They fit in place of your compressor and use the same bolts and bolt holes. No drilling. They contain a pulley the same size as your compressor. They cost around $30. You can use the original belt and keep the same belt routing. That's the best way to go.
yes but would not recmend the belt is pricy and hard to find if your compressor is bad thay do have bypass poleys to but it is also pricy if you need to get some string take the old belt off and go over the poleys with the string bypassing the compressor to get your belt size and go to the auto parts store to get the new belt and put it back on in the same patern as the old one skiping the compressor good luck