Depends on the size of the circuit which you did not list.
Depends on length. The more length, the more resistance.
The 240 volt receptacle has to have an amperage rating. It is this rating that governs the wire size and breaker size to feed the circuit. The new two pole breaker will be inserted in the 100 amp distribution if space is available and connected to the new wiring that terminates at the new receptacle.
i just left lowes an they told me to run 100 amp to my building i would need wire size 2-2-2-4 alumninum and run it in conduit the lowes around here does not sell copper wire that size
A 100 amp service requires that you use AWG 4 copper wire or AWG 2 aluminum wire.
# 4 copper wire short distance.
Depends on length. The more length, the more resistance.
2AWG.
I would use AWG # 4 copper.
15,000 watts at 240 volts will use 62.5 amps. Therefore you will need to use AWG #3 wire on a 100 amp breaker.
For a 220 volt 100 amp breaker, you would typically need a wire gauge of 2/0 AWG (American Wire Gauge) or larger. It is recommended to consult with a professional electrician to ensure the proper gauge is used for your specific installation.
In a floor lamp or table lamp a #16 wire is what you need.
The 240 volt receptacle has to have an amperage rating. It is this rating that governs the wire size and breaker size to feed the circuit. The new two pole breaker will be inserted in the 100 amp distribution if space is available and connected to the new wiring that terminates at the new receptacle.
Volts * Amps = Watts 12 V * ?Amps = 100 Watts OR ? Amps =100W/12V OR 8.33 Amps = 100W/12V Use a 10Amp fuse inline and you can get by with 16Ga wire.
A 400 MCM copper conductor will limit the voltage drop to 3% or less when supplying 100 amps for 700 feet on a 240 volt system. This size will allow the conductor to be loaded to 80 amps. 100 x 80% = 80 amps. Conductors are only allowed to be loaded to 80% or their rated capacity. If you need the full 100 amps then you would need to use a wire with a rating of 125 amps. 125 x 80% = 100 amps. A 600 MCM copper conductor will limit the voltage drop to 3% or less when supplying 125 amps for 700 feet on a 240 volt system.
i just left lowes an they told me to run 100 amp to my building i would need wire size 2-2-2-4 alumninum and run it in conduit the lowes around here does not sell copper wire that size
Use the Related Link Website. At the same website check out wire size calculator. You need a #8 wire to get a full 30 load at 100 feet.
Service wire for 100 amps requires AWG #3 copper.