0
What size service head is needed to power 250 amp 415 volt installation?
Wiki User
∙ 14y ago
If you use 250 or 300 MCM wire you will need a 2 1/2" weather head. If you use 300 MCM wire then you will need a 3" weather head.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you change head on motor for 93' Saturn Sl2?
Get a service manual. Removal of the timing chain cover and head is needed first.
What is the cable between the service panel and electric meter called?
Whether you have an overhead or underground feed, that section of the installation is referred to as Service Entrance Conductors. On an overhead installation, it includes the conductors on BOTH sides of the meter, from the service drop conductors (attached at the service head) to the service equipment LINE terminals. On an underground installation, it refers only to the conductors between the meter's LOAD side and the service equipment LINE terminals. The conductors on the LINE side of the meter come from a distribution transformer and are unbroken between the transformer and your meter.
What is still head in fractional distillation?
This is the top of a distillation installation.
Is head start a social service?
head start is a social service.
How did Manuel Noriega take power?
Manuel Noriega gained his power by working up through the various ranks of the military. He was at one time the head of the Panamaâ??s Intelligence Service. He was feared by many which is how he got to be the head of the country.
Can you run coaxial in the same PVC conduit as the electric service?
No, the utility company wants nothing but the service wires in the service stack. Another weather head can be installed to accept your cable and telephone service positioned adjacent to the service stack. If underground service a separate conduit to the comunications pull box will be needed.
Can improper installation of a heater core cause a blown head gasket?
No
Installation of a crankshaft position sensor on your Chevy Metro?
it is located on the head
How do you replace the head gasket on a 1980 Datsun pickup?
you buy a manual and read the section referring to head gasket installation.
Do you need a special tool to remove the power steering reservoir cap?
There is no special tool needed to remove the power steering reservoir cap of a Volkswagen Golf. It can be removed with a flat head screwdriver.
The gross head in turbine installation is difference of level between?
it is difference between the water level from head race and tail race
Hydroelectric power depends on what two things?
A hydroelectric generator requires two things to produce power; water and head. Water is obviously needed to spin the turbine, and head is the difference in altitude between the surface of the water in the reservoir above the generator and the water turbine at the generator.
