0
# 3 gauge
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
What size wire is required for a 220 volt at 54 amps?
For a 220 volt circuit at 54 amps, you would need a wire rated for at least 6 AWG (American Wire Gauge) size to handle the current safely. It's always recommended to consult with a licensed electrician or refer to local electrical codes for specific requirements.
How long does current remain in a 220 volt circuit?
The current in a 220 volt circuit depends on the resistance of the load connected to it. Ohm's Law (I = V/R) states that current (I) is equal to voltage (V) divided by resistance (R). So, the current will vary based on the resistance of the circuit.
Can you use a neutral wire from a existing 110 volt 20 amp circuit to supply a neutral for a washer dryer combo that has only a 220 volt 30 amp 2 wire?
No !
How do you install a 2 pole CB 220 volt using AWG eight two wire to fuse box?
To install a 2-pole circuit breaker for a 220-volt circuit using AWG 8 wire, first, make sure the breaker is compatible with your electrical panel. Turn off the main power, remove the panel cover, and install the breaker in a vacant slot. Connect the black and red wires (hot), the white wire (neutral), and the green or bare wire (ground) to the appropriate terminals following local electrical codes and regulations. Finally, turn the main power back on and test the circuit. If you are unsure about any step, consult a licensed electrician.
What size in a 90 amp 220 volt circuit?
4 AWG copper or 2 AWG aluminum.
Is a 220 volt electrical power wire the same as a 240 volt electrical power wire?
Yes 220 & 240 are considered the same.
What size wire do you need for 20 amp 220 volt electric motor?
12 AWG in most circumstances.
Can you use the ground conductor in a 14 AWG 2 conductor with a ground for the neutral in a 220V 15 amp circuit with less than 50ft run?
yes <<>> No, the ground wire is never to be used as a neutral. In this case if you need a 120 volt circuit from the 220 volt circuit a three wire cable (3C #14) must be installed.
Can you supply three 220 -240 volt 16.6 amp infrared heaters with one circuit?
Can you supply three 220 -240 volt 16.6 amp infrared heaters with one circuit?
Can 110 volt apliance work on 220 volts circuit?
NO - that is dangerous.
What size wire do you need for 220 feet?
Cannot answer this question. Will need to know the voltage and amperage of the circuit. Also need to know the application i.e. is it a lighting circuit or a motor circuit?
What wire color is ground on a 4 wire 220 volt cord The I know the green is and what red black or white?
Depending on the configuration of the cord cap, the green wire is ground, the white wire is the neutral and red and black wires are the 220 volt source.
