0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is the r-parameters of transistor?
r parameter is resistance parameter
What are a completely mixed flow reactor and its concentration characterisrtics?
a completely mixed reactor. the concentration in the reactor is the same that flows our of the reactor
How many percent efficient is the nuclear power plant?
Approximately 33%, depending on the design. That's measuring from reactor thermal power to final electric power.
What is the desired target value for a parameter?
The target value of a parameter is the perimeter.
What is the name of India's first nuclear reactor?
India's First Nuclear Reactor was Apsara. It was also the first nuclear reactor in Asia. Apsara went critical at Bhabha Atomic Research Centre (BARC), Trombay on August 4, 1956. It heralded the arrival of India's nuclear energy programme. Dr. Homi Bhabha himself conceptualised the design of the reactor and the reactor was built entirely by Indian engineers in a record time of about 15 months.Apsara is a swimming-pool-type reactor loaded with enriched uranium as fuel. The fuel core is suspended from a movable trolley in a pool filled with water. The pool water serves as coolant, moderator and reflector, besides providing the shielding.
Are radioactive isotopes produced in a nuclear reactor?
They can be, depending on the reactor design.
What are system design parameter?
Which of the following is NOT a system design parameter? Human Systems Integration (HSI), Reliability and Maintainability, Standardization, DOTMLPF Change Recommendation
To create a parameter query enter a parameter rather than a specific value as a criterion in the design grid the parameter must be enclosed in?
Square brackets []
How many control rods are there in a nuclear reactor?
The number of control rods in a reactor will vary with the size and the design.
What has the author Peter Harriott written?
Peter Harriott has written: 'Chemical Reactor Design (Chemical Industries)' 'Chemical reactor design' -- subject(s): Chemical reactors, Design and construction 'The effects of porous and solid fillers on the permeability of cellulose acetate membranes'
What going to happen if the nuclear power plant melts down?
A meltdown is both good and bad:Good reactor design uses the meltdown to disassemble the fuel into a subcritical mass, causing the reactor to automatically shutdown.Bad reactor design can allow the fuel to enter places it should not go, possibly causing steam explosions, contamination outside the reactor containment, etc.
What is equilibrium conversion how does it effect design of reactor?
equilibrium conversion is that which is at equilibrium concentration
Error message invalid parameter. What is the valid parameter?
Generally speaking it is an error in the web page or program design which is trying to tell the computer to do something that is 'invalid'. The invalid parameter message is usually followed by a short blurb telling you what line the error is on.
How long are the fuel rods typically left in the reactor core in a BWR or a PWR?
The length of time we see fuel rods left in the core of a reactor will depend on the time it takes to deplete the nuclear fuel in those rods. Reactor design, specifically fuel rod design, and the rate at which the fuel is consumed during operation all have an effect. Typical life of the fuel in a nuclear reactor at a power station is several years.
How much kgs of U-235 can a reactor core hold?
that would depend on the core design and size.
What has the author Uzi Mann written?
Uzi Mann has written: 'Principles of chemical reactor analysis and design' -- subject(s): Chemical reactors, Design and construction
How many fuel rods in a reactor?
The number of fuel pins in a reactor will vary depending on its design and objectives. In one reactor that I worked with, I seem to recall 137 fuel assemblies, with four bundles each, with 62 fuel pins each. That translates to 33,976 fuel pins in the reactor, each about 12 feet long.
