ROM Read Only Memory
A router is not part of the PS3 hardware, you must purchase a router if you need one.
You can use a wireless connection if you have a wireless router
No, a wireless router is needed to have the internet accessible on the Wii.
Your router goes on then off, as many times as you turn it, on then off.
to run the internet in your psp you have to have a wireless router. go to internet and you have to set connection with your router by putting the router code and have your wlan switched on. then you can use the internet on your psp
The startup config is what has been saved to the memory (using write mem) and is used when the router is powered on. You can change the startup config after it has been powered up, this would be the running config. If you power the router off without saving the changes, it would revert to the startup config.
loading Cisco IOS software
Cisco router memory has over 120 gigabytes. That is a lot of memory for a router. This item can be found on either eBay or Amazon for a very cheap price.
When a router boots up, it performs a series of steps, called the boot sequence, to test the hardware and load the necessary software.1. The router performs a POST. The POST tests the hardware to verify that all components of the device are operational and present. For example, the POST checks for the different interfaces on the router. The POST is stored in and run from ROM (read-only memory).2. The bootstrap looks for and loads the Cisco IOS software. The bootstrap is a program in ROM that is used to execute programs. The bootstrap program is responsible for finding where each IOS program is located and then loading the file. By default, the IOS software is loaded from flash memory in all Cisco routers.3. The IOS software looks for a valid configuration file stored in NVRAM. This file is called startup-config and is only there if an administrator copies the running-config file into NVRAM.4. If a startup-config file is in NVRAM. the router will load and run this file. The router is now operational. If a startup-config file is not in NVRAM, the router will start the setup-mode configuration upon bootup.
Inside the router's chassis.
• load bootstrap, load IOS, apply configurationsource :http://learn-ccna.net/907-which-of-the-following-is-the-correct-flow-of-routines-for-a-router-startup-907-20091511.html
from a tap on a field coil
a Wireless router.
Unless there are static ARP mappings, the cache will be cleared when powered off.
NVRAM, ROM, and flash memory
NVRAM
NVRAM