Auto Parts and Repairs
Transmission Fluid
Toyota 4Runner
Ford Explorer XLT

What type of transmission fluid should you put in a 1993 Mazda 626 with a four cylinder engine?


Top Answer
User Avatar
Wiki User
2004-11-02 18:29:11
2004-11-02 18:29:11

dextron3 with mercron


Related Questions

will a 1997 Mazda 626 transmission or engine interchange with a 1999-2002 Mazda 626 transmission or engine

I found a listing for a 1988 Mazda B2600 ( 2.6 L 4 cylinder engine / 3 speed automatic transmission / 4X4 ) and listings for 1990 through 1993 Mazda B2600I ( 2.6 L 4 cylinder engine / 4 speed automatic transmission / 4X4 )


NO!! The Mazda engine and ford engine are totally different period.Mazda was still strickly Mazda until 1993. It was not until 1994 when Mazda and ford became the same on engine and tranmission similarities.You need a Mazda engine for your Mazda transmission.Note the 1986-1993 Mazda bseries trucks are all Mazda manufactured.Ford is not interchangeable with these models period.

The 626 has a PCM which controls both the engine and the transmission.

Yup, and in-line 4 cylinder engine.

the engine can be either a: 1.6 liter 4 cylinder or 1.8 liter 4 cylinder

90,000 miles and it's NOT an interference engine ( according to the Gates website listing for the 2.0 liter 4 cylinder engine in a 2002 Mazda Tribute )

Can you tell what can kind of mazda we talking about (model) ?

The 2002 Mazda MPV 3.0 liter engine has four cylinders. The number four cylinder will be the very back cylinder.

No, it is a Mazda engine. The Zx2 was assembled in Mexico..

The 2000 Mazda 626 transmission dipstick is located in the engine compartment, near the firewall. The transmission dipstick will have a bright yellow handle.

The 2004 Mazda Tribute has two different engines. The 4 cylinder engine uses 4.5 quarts. The 6 cylinder engine uses 5.5 quarts of oil.


Depends, which engine is in the 85, 13b or 12a?

Yes, a Mazda B2000 is most definitely a 4-cylinder with a 2.0L engine. However, technically Mazda didn't produce the B2000 as a 1988 model. It was made in 1986-1987. Then in 1989 Mazda made the B2200 Pickup, which is a 2.2L 4 cylinder.

oxygen sensor is usually in the rear of the exhaust maifold or in the exhaust pipe itself

It is the center to the right of the engine...

NO , the 2.0 L - 4 cylinder engine in a 1995 Mazda 626 ( IS NOT) an interference engine ( according to Gates - they make timing belts etc. )

I'm not sure on that particular engine but it can be found in water jacket on cylinder head, it should have 2 wires and if you remove it there should be coolant behind it.

ford probe is the same engine/transmission configuration

93's are not interchangeable with the other years iknow i have on and tried also an auto to a manual cant be done on the original engine manual has to go on a manual etc. so i wish you luck The above answer is totally wrong. ANY Mazda MX6/MX3/626 or Ford Probe can be changed over to manual transmission easily and quickly. The transmission is the Mazda G25M-R for either the 2.0L FS or 2.5L KL engine depending on what you have. There is no difference in the engine between years that would affect fitment of the transmission. The Automatic transmission is a Ford/Mazda CD4E for the 4-cylinder (FS) and a 4EAT for the 6-cylinder (KL). If you're doing it yourself, the manual transmission swap will yield a dependable car with parts from a junkyard, the automatic replacement will now... unless you're purchasing a Mazda (factory) remanufactured and revised transmission. Go to and check out your options.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.