Most likely is going to explode. Put 120 psi on a car tire rated for 35psi and you will have the same effect.
Answer
The circuit's protective device will disconnect the motor from the supply, It will not explode!
A connection can be taken between phase lines, or between one phase and neutral. Both methods give a single-phase supply. Between phases the voltage is sqrt(3) times more than between one phase and neutral. In each case the load gives an unbalanced current on the 3-phase system but the idea is to average out the unbalances over a group of single-phase loads.
A single-phase cable will have a line and a neutral conductor and, possibly, but not necessarily, an earth (ground) conductor. A high-voltage three-phase cable will have three line conductors. A low-voltage three-phase cable is likely to have three line conductors and a neutral conductor.
An open delta connection is a delta connection with one phase removed, but still supplied with three line conductors. An open wye is a wye connection with one phase removed, supplying a three line conductors and a neutral conductor. An open-delta/open-wye is a method of providing a reduced-load three-phase supply using just two single-phase transformers, rather than the preferred method of using three single-phase transformers.
On a step down transformer XO symbol denotes the secondary split phase grounding point. This is also where the neutral of the three wire secondary is connected. The transformer connection is known as a single phase - three wire - with one secondary winding.
As far as I understand, you don't need neutral line for connecting appliances that is 3-phase compilant. You only need the neutral line to connect a single phase appliance, which you connect along with one of the three lines.
Unless the switch has a light to indicate the switch is turned on, there is no neutral connection to a single pole switch.
In a single-phase circuit like a house fed from 4-wire three phase in the street, the current flows in the live and neutral wires. The neutral currents from a street of houses are expected to cancel each other so that the overall current in the neutral leaving the transformer is small.
Monster Ball
If the load is not grounded and has no connection to neutral then nothing should happen. This begs the question of why you would do such a thing. If you touch any metal part on the load you will likely get a shock.
A connection can be taken between phase lines, or between one phase and neutral. Both methods give a single-phase supply. Between phases the voltage is sqrt(3) times more than between one phase and neutral. In each case the load gives an unbalanced current on the 3-phase system but the idea is to average out the unbalances over a group of single-phase loads.
Neutral-not moving;on a single position
Nothing should happen; that is reason you have fully redundant links, in case a link fails.
monster's ball
Neutral is a return path.
A single-phase cable will have a line and a neutral conductor and, possibly, but not necessarily, an earth (ground) conductor. A high-voltage three-phase cable will have three line conductors. A low-voltage three-phase cable is likely to have three line conductors and a neutral conductor.
The world would change majorly!!!!!!!!!
The single electron in a neutral hydrogen atom resides in the 1s orbital.