0
To adjust the valves on a 1978 Chevette, start by ensuring the engine is cold. Remove the valve cover, then rotate the engine to align the timing mark on the crankshaft with the TDC mark on the timing cover for cylinder number one. Use a feeler gauge to check the clearance between the rocker arm and the valve stem; the specifications are typically around 0.008 inches for intake and 0.010 inches for exhaust. Adjust the rocker arms by loosening the lock nut and turning the adjusting screw until the proper clearance is achieved, then retighten the lock nut and repeat for the remaining cylinders.
What else can I help you with?
What is the difference between a diagnostic procedure and a therapeutic procedure?
diagnostic procedure discovers whats wrong, and therapeutic procedure treats whats wrong
What is the difference between a therapeutic procedure and a diagnostic procedure?
diagnostic procedure discovers whats wrong, and therapeutic procedure treats whats wrong
Ford 3.0L valve clearance?
Whats the valve clerance on a 98 taurus?
Whats the procedure for preparing the micrometer for use?
This is a stupid question.
What is the difference between solenoid valve and control valve?
I believe that servo is motorized and solenoid is magnetically activated.
Whats the valve lash on a 94 Ford 302?
usually .0020
What is the procedure for replacing a 2002 Buick Lesabre front strut?
Whats the procedure for replacing a 2002 Buick Lesabre front strut.?
Whats the firing order for a 1994 corsa 1.2 8 valve?
2,3,1,4
Whats the recruitment procedure in go air?
The Sales Force Recruitment of HDFC Bank?
What is the torque spec for valve covers of a 2.5L Mitsubishi?
whats a head bolt torque of l300diesel2000
What is the valve clearance on a Nissan safari TD42 4.2L?
whats the tappet setting for a nissan td42
For a Paintball Marker CO2 tank Which is better A Repeater Valve or an On SLASH Off Valve?
A repeater valve is so much cheaper. So go with that one anyway. But whats the difference between the two?
