a reverse fault
Yes! The HANGING WALL is usually associated with / occurs on, the upper face of a near-vertical fault. It is evidenced when a mineral vein which follows a fault has been worked out and then can produce a danger of fall where the rock is fractured
A normal fault is a fault in which the hanging wall has moved downward relative to the footwall.
The footwall is the block that is below the fault. The hanging wall is the fault block that is above the fault.
a hanging wall is the pieces or rock that that forms the upper half of a fault.
In a normal fault the hanging wall moves downward. With this type of fault, the hanging wall also shifts horizontally away from the fault line.
a reverse fault
a reverse fault
thrust
In a non-vertical fault (where the fault plane dips), the footwall is the section of the fault that lies under the fault, while the hanging wall lies over the fault.The names come about from the mining industry because important ore minerals were commonly deposited along fault planes. In a mine along a fault, the miner would be standing on the block lower block and hanging his lantern from the upper block (hence, foot wall and hanging wall).In perfectly vertical faults, you cannot designate a footwall or a hanging wall.
No. With a fault there are two different blocks of rock moving against one another. If the fault is not vertical then the block on top is the hanging wall and the block on the bottom is the footwall.
Yes! The HANGING WALL is usually associated with / occurs on, the upper face of a near-vertical fault. It is evidenced when a mineral vein which follows a fault has been worked out and then can produce a danger of fall where the rock is fractured
its when a hotdog becomes mush when it gets eaten
A normal fault is a fault in which the hanging wall has moved downward relative to the footwall.
The footwall is the block that is below the fault. The hanging wall is the fault block that is above the fault.
This is known as a reverse or thrust fault and is formed by compressional forces.
This is known as a reverse or thrust fault and is formed by compressional forces.
reverse fault. but that is when the foot wall moves down, the hanging wall moves up. in a strike-slip fault, they slide past each other, the foot wall and hanging wall are not there because it has to be like this to be a reverse or normal fault: hanging wall ----------foot wall ----------- in this diagram, the foot wall has moved down making the hanging wall move up to form a reverse fault. remember this on tests: the hanging wall is always above the fault line: /hanging wall above foot wall below / /