Want this question answered?
No machining is advisable when material to be machined is red hot rather it can be forged, extruded. Primary machining only is normally advisable when material is red hot.
Yes
depends on how fast your writing. but still i cant imagine it being that hot!
The reduction of the diameter of a stainless steel bar by hot or cold work will usually increase the strength and lower the elongation. However after the normal annealing the mechanical properties will be about the same as before it was reduced in diameter. If the reduction is by machining, the properties will remain the same unless it is overheated.
no as it will burn out the element
No machining is advisable when material to be machined is red hot rather it can be forged, extruded. Primary machining only is normally advisable when material is red hot.
themometer
grams
Wash measuring spoons in hot soapy water and dry them well.
How fast molecules are moving. If they are moving fast its hot, but if they are moving slow it is cold
put a thermometer on it and see how hot it is
yes it is still a hot dog
Its a temperature sensing device or thermocouple for measuring how hot your computer hardware is
... amount of energy in the soup molecules.
You don't provide enough information to be certain what you are measuring. If you have a hot leg then by definition you will have a voltage between the hot leg and ground or neutral (if neutral bonded properly to ground in main panel). However, there may be no voltage between hot and some unspecified "floating" wire.
same as measuring it in warm or hot places.
Measuring the temperature with adequate instruments.