Whenever the combination has been compromised or when someone leaves or is no longer to have access using the lock.
NOPE
there should be a little hole on it somewhere the u stick somthing in side of it then you just change it
You have to have a combination. If you have a key lock you don't need a combination, all it is is a lock that says master and a key to turn it and then it opens what you have in it.
It depends on the make of the lock. Many time you need to know the combination. Sesame locks require a pin that goes in the shackle hole when the shackle is 180 degrees from open. Master combination locks with a scroll combination require a reset key that can only be used when the current combination is known in order to change. Other padlocks require the lock to be open and the shackle turned 180 degrees and pushed down while setting the combination.
use a fire hyderant and bang it in a downward motion hitting the lock. do this a couple of times and it should do the trick.
The computer network security does not constitute the mandatory changing of the cipher lock combination.
A person could change the code on a Cipher lock by taking the whole lock apart and going into the innards of the lock and changing the cadences of the lock around to what they want it to be.
First of all, you need to unlock it. If you don't know the current combination: it can't usually be changed. Then, you need to set your new combination and lock it. It should then be set.
That depends on the specific kind of lock.
A lock refers to a number of types of device for securing a door. While there are combination locks, smart card locks, and keyed locks, the mechanism known as a cipher lock is opened with a programmable keypad and - according to definition - is not a true lock. There is also a specific type of cipher lock called a Cypher Lock®, which was developed by Continental Instruments, now a division of Napco Security Group. The U.S. Army distinguishes the use of cipher locks and keyed locks, stating that the purpose of keyed locks is to maintain physical security, while the purpose of cipher locks is to control access, limiting either unannounced intrusions or unescorted entry to particular areas of a facility that are sensitive. Cipher locks are used to control access to areas such as airport control towers, computer rooms, corporate offices, embassies, areas within financial institutions, research and development laboratories, and storage areas holding weapons, controlled substances, etc. A cipher lock may have four or five pushbuttons, depending on the manufacturer. Even with five pushbuttons, the code may be one to five digits. When the cipher lock unit is set up the code is programmed and shared with authorized personnel. It can be changed at any time.
NOPE
If you don't know the code to the combination lock then your stuffed. Just go through all the possible combinations and unlock it (only if its a 3/4 digit) On the other hand if you do know the code and want to change the lock, hold down the unlock button/lever and change the digits and that should change the code.
there should be a little hole on it somewhere the u stick somthing in side of it then you just change it
Because it should be called a permutation lock.
restore it w/ itunes
To change the combination on a TSA lock, you will need to locate the reset button on the lock. Press and hold the reset button while setting your desired combination. Release the reset button and test the new combination to ensure it is working properly.
To set your personal cipher, follow these steps: 1- Open the lock (the original number is 0-0-0). 2- Pull lock's hook to the end, hold the position until the third operation had been performed. 3- Set your secret code by turning the wheels then release the hook. 4- Press the hook into lock's slot, turn the wheels to the other cypher, the hook can't be pulled. it is locked.