You will have to research old gun catalogs.
100-300 USD or so
100-300 USD
100-250 USD or so
If its the sigma model sw380 then the only real trick is to remove the rear most pin located at the rear high on the back strap. That portion where the web of your thumb and pointing finger rests on the rear of the gun. That is the only pin you need to drive out with the tool that comes with the kit. That's the only pin you should remove. Dont mess with the pin located above the trigger. Careful not to loose any parts. I should also think you could Google the manual or find it from the makers web site. Its an easy take apart and its reverse to put it back together.. Refer to Brownells Schematics online .com : listed as part 17 ~ rear sear pin ; yet no definition on the proper tool but S&W has takedown tool available from Brownells for K,L,N frames { 1 tool } revolvers ?
If its the sigma model sw380 then the only real trick is to remove the rear most pin located at the rear high on the back strap. That portion where the web of your thumb and pointing finger rests on the rear of the gun. That is the only pin you need to drive out with the tool that comes with the kit. That's the only pin you should remove. Dont mess with the pin located above the trigger. Careful not to loose any parts. I should also think you could Google the manual or find it from the makers web site. Its an easy take apart and its reverse to put it back together.. Refer to Brownells Schematics online .com : listed as part 17 ~ rear sear pin ; yet no definition on the proper tool but S&W has takedown tool available from Brownells for K,L,N frames { 1 tool } revolvers ?