yes and thank you for asking the questien
Left front.
To bleed brakes on your 2008 Uplander front and rear, disconnect the brake line at the caliper.
Hello, You always start with the line that is furtherest from the master cylinder which is usually the passenger side back. then the driver side back, passenger side front,driver side front. It usually don't take much for the back just bleed each one two or three times each. Depending on which one you replaced on the front you need to bleed it until there is no air spitting out. You need two people to do this. One to pump the brake and hold it down. while the other bleeds the brakes. BE SURE TO KEEP A CHECK ON THE FLUID!!
Air in the system. Bleed the brake system.
Replace and bleed line
I'm finding it hard to stop i think i need to bleed or tighten up the front brake HELP?
why after changing my front brakes on my Nissan altima,my brakes peddle got really soft YOU FORGOT TO BLEED YOUR BREAK LINES~! GO TO AUTOZONE, OR PEPBOYS OR ADVANCED AUTOPARTS AND GET A BRAKE BLEEDER KIT..THEY ARENT EXPENSIVE AND ALLOW YOU TO BLEED YOUR BRAKE SYSTEM ON YOUR OWN.
Always best to bleed both sides if you change a brake line. EG: Both front or both rear.
blled both front and rear in this order Passenger Rear, Driver Rear, Passenger Front, Driver Front.
You're supposed to bleed all four brakes or you really arent doing anthing, you could also cause improper and uneven wear on the brake pads them selves
Does this Blazer have four wheel disc Brakes? NEW ANSWER: There's no reason to bleed brakes if you did not open the system.( where brake fluid came out )
I have found that its a bit easier if you let the pressure out of the brake lines. BUT if you do that make sure you bleed your brakes and add brake fluid afterward