Positive is usually indicated by the color red or by a "+" symbol. Negative is indicated by black or by a "-" symbol.
by taking the cables out
to reset the computor..all you have to do is take the negative battery cable off for about 10 min. then tighten back on. tada!
MINECRAFT
Normally it means the alternator is defective.
Pontiac Aztek was created in 2001.
To change the shift solenoid in a 2002 Pontiac Aztek, first disconnect the negative battery cable to ensure safety. Then, remove the transmission pan and fluid to access the solenoid. Locate the shift solenoid, disconnect its electrical connector, and unbolt it from the transmission. Replace it with the new solenoid, reassemble the transmission pan, refill the fluid, and reconnect the battery.
unplug the battery for 15- 20 mins it should reset it i think
fuse abs pontiac aztek 2002 located
To replace the blower motor on a 2004 Pontiac Aztek, first disconnect the negative battery cable to ensure safety. Remove the passenger side lower dash cover and the blower motor's electrical connector. Unbolt the blower motor from its housing and carefully pull it out. Install the new blower motor by reversing the steps, ensuring all connections are secure before reconnecting the battery.
To change the alternator on a 2001 Pontiac Aztek, first disconnect the negative battery cable to ensure safety. Remove any components obstructing access, such as the engine cover or air intake. Then, disconnect the electrical connections to the alternator, unbolt the mounting brackets, and remove the serpentine belt. Finally, install the new alternator by reversing the steps, ensuring all connections are secure before reconnecting the battery.
To change the mass air flow (MAF) sensor in a Pontiac Aztek, first ensure the engine is off and disconnect the negative battery cable. Locate the MAF sensor, which is typically found between the air filter and the throttle body. Unplug the electrical connector, remove the mounting screws, and take out the old sensor. Install the new MAF sensor in the same position, secure it with screws, reconnect the electrical connector, and reattach the negative battery cable.
The only thing you need to reset is the clock and radio station presets.