Toyota SR5

Where are the oxygen sensors located in a 1989 Toyota sr5?


Top Answer
User Avatar
Wiki User
2014-09-17 16:02:13
2014-09-17 16:02:13

Oxygen sensors on a 1989 Toyota SR5 and located near the catalytic converter. The sensors read the emissions from the vehicle so the ECU knows ho much fuel to run in the engine.


Related Questions

O2 sensors are located in the exhaust system.

Toyota V6 1989 Oxygen senson is located on the driver side in front of the catalytic convertor. It has four wires and held on by 2 bolts.

On my 1989 f250 the oxygen sensor is in the exhaust header pipe a few inches in front of the catalytic convertor

All Oxygen Sensors are located in the exhaust eitherbefore or after the catalytic converter. Your O2 sensor may not be defective as a vacuum leak can cause the code.

According to the 1989 Ford Mustang GT has ( 1 ) oxygen sensor

They should be on the exhaust manifold visible from under the hood.

Don't think the 1989 Toyota Camry came with an airbag system.

There is one and it is before the catalytic converter.

If you have the 302 or the 351W (5.0L or 5.8L), the oxygen sensor is located at the front of the first cat converter. It only has one and its on the passenger side. you cant miss it

There are two oxygen sensors on a 1989 Crown Victoria. One is located on each of the exhaust pipes coming off the exhaust manifold.

There are three coolant sensors installed to a 1989 Toyota Corolla 1.6 GL. One is a thermostatic valve switch that controls vacuum lines and is located near the passenger side of the carburetor and below the intake manifold. This can be identified by the hoses connected to it. The two other coolant sensors are located immediately before the big water hose leading to the radiator (upper hose). These two sensors can be identified by their electrical connectors. The bigger terminal is connected to a relay that controls the operation of the radiator fan. The smaller terminal is connected to the temperature gauge at the instrument panel.

where is the rear defogger relay located in a Toyota Camry

Should be located at the driver's side firewall

The ECM (computer) is located on the passenger side kick panel!

Crank sensors are always located on the camshafts. The 1989 Pontiac Sunbird crank sensor is located on the head of the engine towards to end of the camshaft.

the starter should be under the intake on the back of the motor.

It is located on the bottom of the windshield washer reservoir.

Mounted on top and inside the fuel tank.

on the exhaust. its that spark plug looking thing that screwed into your exhaust usually before your cat or muffler

The fuse for the wipers on a 1989 Toyota pickup are located under the dash, near the hood release. It is in the main fuse panel which controls most of the vehicle's electronics.

The fuel filter on a 1989 Toyota Supra is located just below the fuel tank along the vehicle's frame. It is positioned inline and must be replaced periodically.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.