The timing marks for the cam sprocket on a 98 S10 is on the front. The marks for the crank shaft is on the oil pump gear.
Generally, for most single cam engines, there is a dot or mark on the cam sprocket and a similar mark on the crank sprocket. Point them at each other. the timing marks on the crank and cam sprockets must be lined up with marks on the timing chain in an overhead cam engine
The cam gear timing marks for a Isuzu 320 V6 are located on the cam sprocket and the timing chain itself. The marks must be aligned with each other to ensure proper initial timing.
The cam timing on a 4.6 SOHC engine is set by aligning the timing marks of the timing chain to the cam sprocket. This sets the initial timing based on factory settings.
The timing marks for a 2002 Ford Explorer are located on the timing chain and cam shaft sprocket. They must be aligned with each other to set the initial timing.
ON MY 2.2 4CYLINDER ( 1999 ) YOU HAVE TO PULL THE TIMING CHAIN COVER TO SEE THE " TIMING MARKS " . ON THE CRANK SPROCKET IT IS A PUNCH MARK.....ON THE CAM SPROCKET IT IS A SMALL HOLE IN THE SPROCKET . BOTH MUST LINE UP WITH TABS ON THE CHAIN TENSIONER. THE REST OF THE TIMING IS DONE BY CRANK & CAM SENSORS AND THE COMPUTER.
A cam sprocket is a part which is attached to one end of a cam shaft in an engine. A cam sprocket, along with the timing belt maintain the timing between the camshaft and crankshaft, which ensures that the engine runs properly.
assuming youre replacing the timing chain. the cam and crank sprocket marks are to point directly towards each other.
The timing marks on a 1992 Hyundai 1.5 are lined up by placing the indicators on the cam sprocket and crankshaft sprocket across from each other. This sets the initial timing which determines which determines the synchronization between the engine's internals.
On a 2001 Smart Car, the timing marks for the timing chain are located along the cam sprocket and the edge of the links. They must be matched together to ensure proper initial timing.
when using a timing light, the marks are usually found on a tab/plate mounted n he engine above the crankcase damper. in timing belt instalation, the marks are place on the valve cover(s), cam sprocket(s) and crank sprocket. it depends on the engine type and the area of "timing" involved.
The timing marks on a 1969 Ford 360 should line up between the timing chain and the cam sprocket. This sets the initial timing which can later be adjusted using a timing light.