0
What else can I help you with?
Where do you put the transmission fluid in a 1993 Mazda Mx6?
I know if you have an auto transmission v6 Mazda mx6 93. You can put the transmission fluid in a 1993 Mazda Mx6 v6 from where you check the dip of transmission fluid. It is located close to the battery and close to the fuel filter. Its cap is orange color. For the manual transmission, you have to look under neath of the car, there is a bolt for drain and a bolt for to fill. Look around it, you will see it.
Where is the tension release bar to put the alternator belt on a 1993 Mazda Mx6?
ok buddy , i am talking about 1993 Mazda mx6 4 cyl. when you look down you can see the one side of the alternator . put your hand on the back side which you can't see you will find a mounting bolt .you will feel it with your hand . that needs to be loosened first before you can loosen that the long tension bar . good luck , i just replaced the drive belts today ...ouff azzaro
What happens when you put the wrong water pump on 1994 Mazda mx6?
It either works or it doesnt
What type of motor oil should you put in a 1990 Mazda mx6?
5-40 fully synthetic
How do you adjust the timing on a 1993 Mazda mx6?
there should be timing marks on the pully for the drive belt. If not take out the number 1 spark plug and put a crew driver in the hole. Bump the motor until the piston is top dead center. Then put your belt on and put your spark plug back and your good.
Why does 93 Mazda mx6 stall when put in drive or reverse ive driven it for almost 4 months then all the sudden this its fine when its in drive or neutral but if i put it in park or drive it dies?
It might be a problem with your transmission because not all mx6's stall when you put it in drive or reverse.
How do you replace the radiator in a 1993 323 Mazda?
first drain then undo clips holding it in then then undo hoses put in new one do up hoses then replace clips then fill with 50/50 coolant and water
In What Order Do You Put Spark Plug Wires on a 1993 Mazda mx3 4 cylinder?
1234
Why would a Mazda MX6 manual transmission stall when put in gear?
Ignition module is bad I had a similar problem on a Pontiac grand am- it was the torque inverter. It would idle fine, run in nuetral, but as soon as it was put into gear it stalled with a thump.
How do you put brakes on a Mazda mx6?
take off the tire remove the caliper replace the brake disc if necessary and replace brake pads on the calipers reassemble do this for every tire to wish to change at that time
How do you drain coolant in 2004 Mazda rx8?
go under the car and locate the radiator in the left side you will see a small plastic bolt remove it and the the coolant will be out after its empty put it back and done.
What type of transmission fluid should you put in a 1993 Mazda 626 with a four cylinder engine?
dextron3 with mercron
