answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Where do you connect your dionotic tool on 230Clk?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the function of crimping tool?

is a tool use to crimp or connect a connector to the end of a cable..


What tool is used to connect a cat5e cable wire to idc contat?

a punch down tool


What tool is used to connect a cat5e cable wire to idc contactor?

A Punch Down Tool


Front suspension knocking noise on a Mercedes Benz 230CLK?

most likely the anti roll bar bushes. It was on mine


How do you reconfigure the front control module in a 2011 jeep wrangler?

That is a dealer only function. They have to use there scan tool and connect to Chrysler through the internet.That is a dealer only function. They have to use there scan tool and connect to Chrysler through the internet.


What tool will help you determine the location of a dirty cross connect?

OTDR


WHAT DOES IT MEAN TO PUT YOUR CAR ON A MACHINE?

You connect an OBD2 scan tool to the diagnosis port.


You need to connect wires to a 110 block Which tool will properly assist in performing this task?

To terminate on a 110 block you will need a punch-down tool.


What is the command in unix to connect to remote terminals?

ssh or telnet in company environment mostly we used ssh and there is one tool called putty, through putty we can connect.


How do you disconnect the push-connect fittings on the fuel filter of 2005 ford ranger?

You need a special tool for the job. The tool is available at most auto parts stores.


What is the special tool needed for removal of the power steering hose on a 1999 Jeep Cherokee sport?

The Power steering hose is attached with a quick-connect that requires a Quick-Connect removal tool that should be available from you local auto-supply store. You need to know the diameter of the tubing / hose connection. There may be a universal tool for a range of sizes.


Is there something you can do to stop the check engine light from coming on saying bank 1 and 2 lean after installing cold air intake?

Sometimes you can connect the diagnostic tool and it will reset the check engine light. You can have Auto Zone or Advanced Auto connect the diagnostic tool for free.