answersLogoWhite

0

The EGR (Exhaust Gas Recirculation) valve on a 2005 Chevy Malibu is typically located on the engine's intake manifold, near the throttle body. It is often mounted on the rear or side of the engine, making it somewhat challenging to access. To locate it, you'll need to look for a cylindrical component with a vacuum line connected to it. Always consult a repair manual for specific diagrams and further details on removal and installation.

User Avatar

AnswerBot

7mo ago

What else can I help you with?

Related Questions

When do you change an egr valve on a 2005 Chevy Malibu?

Whenever it fails.


Where is the shift solenoid valve on a 2005 Chevy Malibu?

its behind the transmission side cover


Where is the 2005 Chevy Malibu antenna located?

I the wind sheld


Where is the fuel filter located on the 2005 Chevy Malibu LS V6 3.5L?

where is the fuel filter on 05 chevy malibu


Where is the crank sensor located on a 2005 Chevy Malibu Classic?

behind the engine


Can gas be siphoned from a 2005 Chevrolet Malibu?

NO it can not as there is a check valve located in the filler neck.


Where is the oil pressure switch located on a 2005 Chevy malibu maxx?

above starter


Does a 2005 Chevy Malibu have struts or shocks or both?

2005 Chevy Malibu, shocks in rear, Struts in front.


How do you remove a water pump on a 2005 Chevy Malibu 2.2 ecotec?

how do I remove a watwr pump on a 2005 chevy malibu


What size door speakers are in a 2005 Chevy Malibu classic?

what size door speakers are in a 2005 Chevy Malibu classic


Where is the fuel filter located on a 2005 Chevy Malibu classic?

The fuel filter is located in the fuel tank and is non-serviceable.


How do you replace PCV valve in 2005 Chevy Malibu?

To replace the PCV valve in a 2005 Chevy Malibu, first, locate the valve, which is typically found on the valve cover or intake manifold. Disconnect any hoses attached to the PCV valve and remove it by twisting or pulling it out, depending on the design. Install the new PCV valve by pushing it into place and reattaching the hoses securely. Finally, start the engine to ensure proper operation and check for any leaks.