All O2 sensors are threaded into the exhaust system at various points.
I have a 2003 Dodge Ram 5.7 4x4. Can you tell me where the IAT Sensor is located ? I have a G-Force chip to install. Also can you tell me the 2 correct wires to use ?
1 3/8 inch deep socket
To locate and change the front speed sensor on a 1998 GMC Sonoma 4X4, first, lift the vehicle and secure it on jack stands for safety. The speed sensor is typically mounted on the front axle housing; trace the wiring harness from the differential to find it. Disconnect the electrical connector, remove the mounting bolt, and pull the sensor out. Install the new sensor by reversing these steps, ensuring the connector is securely attached.
The speedometer signal comes from the ABS sensors. There is one sensor on the top of the rear axle, and one at each front wheel bearing.
The vehicle speed sensor is located on the top of the rear axle.
It depends on if its 4x4 or 2x4. On the 2x4 version its located on the rear of the transmission. If its 4x4 it is located on the transfer case.
Bank 1 is the passenger side of your engine , sensor 1 is before the catalytic converter ( upstream ) on your Ford F-150
There is no speed sensor reset. IT must be repalced if failed.
It is in the top of the rear axle.
The weight of your truck is located on the drivers door post. Its on the sticker that shows your trucks tire size and specs.
The temp sensor is part of the overdrive solenoid inside the transmission, on the valvebody.
At the rear end of the transmission