Dodge Stratus
Oldsmobile Alero
Crankshaft Sensors

Where is a camshaft sensor located on a 1996 dodge Stratus?

262728

Top Answer
User Avatar
Wiki User
Answered
2005-11-14 10:04:07
2005-11-14 10:04:07

The sensor is located inside the distribuitor

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


Where is a camshaft position senser located on a 2006 dodge durango/



4 cylinder it is on the end of the head. 6 cylinder it is in the distributor.


The camshaft sensor is located on the right hand side of the valve cover right below the valve breather tube. It is a simple 2 bolt mount....



Camshaft position sensor is bad


where is the engine speed sensor located on a 1999 dodge stratus 2.4 l


The speed sensor, on your Dodge Stratus, is located on the back of the transmission. The speed sensor has a wire leading to the front wheel.


Camshaft Position Sensor Circuit Intermittent


the brake sensor for the 2001 dodge stratus is located on the inside of the car under the brake paddle.


on the 1998 the camshaft sensor is in the distributor ,you have to change it....you have to change the whole distributor..the sensor is integrated. the crankshaft sensor is located on the block under the cruise control actuator


4 cylinder it is on the end of the head opposite the timing belt. 6 cylinder it is part of the distributor.


There is no such thing as a cam sensor valve. The camshaft position sensor is powered by the PCM, there is no individual fuse.


The 2006 Dodge Durango camshaft position sensor is located on the back end of the head. The position sensor should be labeled as such.



The camshaft position sensor on a 95 Dodge 2500 3.9 is located inside the distributor, under the rotor.




It is on the front of the engine. It aims at the left cam sprocket through the timing cover.


Rear camshaft seal bad. Replace. located behind cam sensor.


The coolant temperature sensor on a 2005 Dodge Neon is located on the cylinder head. It is close to the camshaft position sensor.


The camshaft position sensor on a Dodge Ram 2500 5.7 engine is located at the rear of the camshaft near the top of the motor. It monitors the motion of the camshaft and constantly updates the vehicle's computer.


The timing marks on a '97 Dodge Stratus are located on the timing chain and the camshaft sprocket. They must be aligned to set the initial timing.


The IAT sensor on a 2004 Dodge Stratus 2.4L is located where the radiator hose meets the engine. IAT stands for intake air temperature.


The crankshaft sensor on a 2006 Dodge Stratus is located on the bottom of the engine near the oil filter. It tells the vehicle's computer where the crankshaft is located at any given moment. On the v6 it is on the top of the bell housing.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.