It is on the passenger side of the valve body, inside the transmission.
The governor pressure sensor is located within the transmission's fluid pan. It's mounted on a bracket with three 11 mm bolts and two #25 torx screws. This was on a '99 Dodge Durango with a 5.9 L motor.
The oxygen sensor is located in the exhaust system on a 2005 Dodge Durango Hemi 5.7. There is a sensor located before and after the catalytic converter.
The 2006 Dodge Durango camshaft position sensor is located on the back end of the head. The position sensor should be labeled as such.
Where is a camshaft position senser located on a 2006 Dodge durango/
The vehicle speed sensor is located on the top center of the rear axle.
Where is a camshaft position senser located on a 2006 dodge durango/
In the rear of the drum
The 4.7L 2002 dodge durango has 4 O2 sensors. ref. Chilton's Dodge Durango/Dakota 2001-03 repair manual. page 6-19 (Oxygen sensor - general info and replacement) The upstream oxygen sensor is located before the catalytic converter. The downstream oxygen sensor is located is located after the catalytic converter.
Dodge did not produce the Durango until 1998. It is located on the bell housing on the right side of the engine where the transmission mounts to the engine
The MAP sensor is located on the intake side before the intake manifold.
It is the four wire sensor on the valve body inside the transmission pan.
The vehicle speed sensor signal comes from the abs sensor on top of the rear axle.