You have to remove the fuel system including the plenum and fuel rails, there is 2 knock sensors located on the top of the motor, one in the front one in the back
where is knock sensor on a 2001 sierra 5.3 2wd 1500.
the knock sensors are located in the top of the engine block. The intake has to be removed to get to the sensors.
The knock sensor is on the starter side of the engine. It is abut half way between front and back.
On engine block
where is knock sensor located on a 99 Silverado 1500 4.3
That engine has 2 knock sensors on it and both of them are underneith the intake manifold. You can not see are get to them until the intake has been removed.
Type your answer here... Where IS Cambshaft sensor in 2000 gmc 1500 and what does it do
The knock sensor on that vehicle is located under the intake manifold. The intake manifold must be removed to gain access to the knock sensor.
on top of the block. on the left side under the intake manifold.
It doesn't have one.
under he intake manifold
There is 2 of them on that engine and there both underneith the intake manifold. You will have to remove the intake to even see and get to them. No other way.
Sensor 2 is the downstream sensor (after the catalytic converter). Bank 1 is the drivers side of the engine
There is more than one O2 sensor in that vehicle and they are all threaded into the exhaust system at various points.
It is screewed into the side of the engine block just in front of the starter.Passenger side of the engine. It will have a wire pluged into it.
Both B1 and B2 knock sensors are located under the intake manifold of which has to be removed to gain access to them.
After the catalytic converter (AKA downstream).
The knock sensor is located 5inches into the gastral-flux capasitory chamber with a 300degree turn into the left rear chamber which hold the fluids. -Profesor Nicholson Rowe PhD in car mechanics
The starter of the 1994 GMC Sierra 1500 pickup is located on the dashboard. It is usually attached by a small wire.
Looking for the ESC myself....the Knock Sensor wire is blue though.
There are two knock sensors on a 2001 Chevy 1500 with the 5.3 V8. You have to remove the intake manifold, because both of them are located under it. it is best to replace both knock sensors at one time, and you will need an intake manifold gasket too. There are two knock sensors on a 2001 Chevy 1500 with the 5.3 V8. You have to remove the intake manifold, because both of them are located under it. it is best to replace both knock sensors at one time, and you will need an intake manifold gasket too.
The 1500 Chevy Silverado has two knock sensors. There is one on each side of the block halfway between front and back.
THE ONLY POSSIBLE ANSWER IS: MAYBEYou need to provide the following information:Year1500 or Sierra or Half Ton or 2500 or 3500Engine size.
The thermostat is located on the engine on a 1998 GMC Sierra 1500 standard. The thermostat can be found by following the upper radiator hose directly to the thermostat,